Messages in this thread Patch in this message | | | From | Bich HEMON <> | Subject | [PATCH 1/2] dt-bindings: serial: stm32: add RS485 optional properties | Date | Wed, 28 Feb 2018 10:56:18 +0000 |
| |
Add options for enabling RS485 hardware control and configuring Driver Enable signal: - rs485-rts-delay - rs485-rx-during-tx - rs485-rts-active-low - linux,rs485-enabled-at-boot-time
Signed-off-by: Bich Hemon <bich.hemon@st.com> --- Documentation/devicetree/bindings/serial/st,stm32-usart.txt | 2 ++ 1 file changed, 2 insertions(+)
diff --git a/Documentation/devicetree/bindings/serial/st,stm32-usart.txt b/Documentation/devicetree/bindings/serial/st,stm32-usart.txt index aaeb564..81e0011 100644 --- a/Documentation/devicetree/bindings/serial/st,stm32-usart.txt +++ b/Documentation/devicetree/bindings/serial/st,stm32-usart.txt @@ -16,6 +16,8 @@ Required properties: Optional properties: - pinctrl: The reference on the pins configuration - st,hw-flow-ctrl: bool flag to enable hardware flow control. +- rs485-rts-delay, rs485-rx-during-tx, rs485-rts-active-low, + linux,rs485-enabled-at-boot-time: see rs485.txt. - dmas: phandle(s) to DMA controller node(s). Refer to stm32-dma.txt - dma-names: "rx" and/or "tx" - wakeup-source: bool flag to indicate this device has wakeup capabilities -- 1.9.1
| |