Messages in this thread | | | Subject | Re: [GIT PULL 1/2] bcm2835-dt-next-2018-02-28 | From | Florian Fainelli <> | Date | Wed, 28 Feb 2018 15:35:49 -0800 |
| |
On 02/28/2018 01:39 PM, Eric Anholt wrote: > Hi Florian, > > The following changes since commit 7928b2cbe55b2a410a0f5c1f154610059c57b1b2: > > Linux 4.16-rc1 (2018-02-11 15:04:29 -0800) > > are available in the Git repository at: > > git://github.com/anholt/linux tags/bcm2835-dt-next-2018-02-28 > > for you to fetch changes up to bcc76c4014dce4e3834dbd5b7f6593cbcfbfebe0: > > ARM: dts: bcm2835-rpi-zero-w: Enable OTG mode (2018-02-26 15:02:23 -0800) > > ---------------------------------------------------------------- > This pull request adds automatic BT probing to the Pi Zero W, OTG mode > for the Zero W, the GPIO expander on the Pi3, and fixes I2S probe > (which is disabled by default, but often used downstream) > > ---------------------------------------------------------------- > Baruch Siach (2): > ARM: dts: bcm2835: make the firmware node into a bus > ARM: dts: bcm2837-rpi-3-b: add GPIO expander > > Henry Zhang (1): > ARM: dts: bcm283x: Fix pin function of JTAG pins > > Stefan Wahren (5): > dt-bindings: bcm283x: Fix register ranges of bcm2835-i2s > ARM: dts: bcm283x: Fix probing of bcm2835-i2s > ARM: dts: bcm283x: Apply pull settings to Zero W relevant groups > ARM: dts: bcm2835-rpi-zero-w: Add bcm43438 serial slave > ARM: dts: bcm2835-rpi-zero-w: Enable OTG mode
Merged into devicetree/next, thanks Eric! -- Florian
| |