lkml.org 
[lkml]   [2018]   [Jan]   [9]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
Date
From
SubjectRe: [PATCH net-next v3 4/4] net: mvpp2: 2500baseX support
On Tue, Jan 09, 2018 at 09:59:45AM +0100, Antoine Tenart wrote:
> This patch adds the 2500Base-X PHY mode support in the Marvell PPv2
> driver. 2500Base-X is quite close to 1000Base-X and SGMII modes and uses
> nearly the same code path.

Sorry, also...

> @@ -4668,6 +4692,10 @@ static void mvpp2_port_mii_gmac_configure_mode(struct mvpp2_port *port)
> */
> val |= MVPP2_GMAC_CONFIG_GMII_SPEED |
> MVPP2_GMAC_CONFIG_FULL_DUPLEX;
> + else if (port->phy_interface == PHY_INTERFACE_MODE_2500BASEX)
> + val |= MVPP2_GMAC_CONFIG_GMII_SPEED |
> + MVPP2_GMAC_CONFIG_MII_SPEED |
> + MVPP2_GMAC_CONFIG_FULL_DUPLEX;

I think you'll find you don't need to set MII_SPEED here, since
MII_SPEED selects between 10 and 100, GMII_SPEED always takes
precidence selecting 1000, and 2500 is done by the comphy
increasing the clocks by 2.5x.

--
RMK's Patch system: http://www.armlinux.org.uk/developer/patches/
FTTC broadband for 0.8mile line in suburbia: sync at 8.8Mbps down 630kbps up
According to speedtest.net: 8.21Mbps down 510kbps up

\
 
 \ /
  Last update: 2018-01-14 23:19    [W:0.069 / U:1.028 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site