Messages in this thread | | | Subject | Re: [PATCH v5] gpio: winbond: add driver | From | "Maciej S. Szmigiero" <> | Date | Tue, 9 Jan 2018 14:57:46 +0100 |
| |
On 09.01.2018 14:53, Linus Walleij wrote: > On Sat, Jan 6, 2018 at 12:46 AM, Maciej S. Szmigiero > <mail@maciej.szmigiero.name> wrote: > >> This commit adds GPIO driver for Winbond Super I/Os. >> >> Currently, only W83627UHG model (also known as Nuvoton NCT6627UD) is >> supported but in the future a support for other Winbond models, too, can >> be added to the driver. >> >> A module parameter "gpios" sets a bitmask of GPIO ports to enable (bit 0 is >> GPIO1, bit 1 is GPIO2, etc.). >> One should be careful which ports one tinkers with since some might be >> managed by the firmware (for functions like powering on and off, sleeping, >> BIOS recovery, etc.) and some of GPIO port pins are physically shared with >> other devices included in the Super I/O chip. >> >> Signed-off-by: Maciej S. Szmigiero <mail@maciej.szmigiero.name> > >> Changes from v4: > > This v5 version applied, I also added Andy's review tag. > > Good work!
Thanks!
> Yours, > Linus Walleij
Best regards, Maciej Szmigiero
| |