lkml.org 
[lkml]   [2018]   [Jan]   [30]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
SubjectRe: [PATCH v2 0/5] selinux:Significant reduce of preempt_disable holds
From
Date
On Fri, 2018-01-26 at 15:32 +0100, peter.enderborg@sony.com wrote:
> Holding the preempt_disable is very bad for low latency tasks
> as audio and therefore we need to break out the rule-set dependent
> part from this disable. By using a RCU instead of rwlock we
> have an efficient locking and less preemption interference.

NB: rcu_read_lock() may disable preemption as well if
CONFIG_PREEMPT_COUNT=y. I assume you aren't concerned with that
configuration?

>
> Selinux uses a lot of read_locks. This patch replaces the rwlock
> with RCY that does not hold preempt_disable.
>
> Intel Xeon W3520 2.67 Ghz running FC27 with 4.15.0-rc9git
> (+measurement)
> I get preempt_disable in worst case for 1.2ms in
> security_compute_av().
> With the patch I get 960us as the longest security_compute_av()
> without preempt disabeld. It very much noise in the measurement
> but it is not likely a degrade.
>
> And the preempt_disable times is also very dependent on the selinux
> rule-set.
>
> In security_get_user_sids() we have two nested for-loops and the
> inner part calls sittab_context_to_sid() that calls
> sidtab_search_context() that has a for loop() over a while() where
> the loops is dependent on the rules.
>
> On the test system the average lookup time is 60us and does
> not change with the RCU usage.
>
> To use RCU the structure of policydb has to be accesses through a
> pointer.
> We need 4 patches to get there.
>
> [PATCH v2 1/5] selinux:Remove direct references to policydb.
> We remove direct references and pass it through function arguments.
>
> [PATCH v2 2/5] selinux: Move policydb to pointer structure
> Move the policydb to dynamic allocated structure.
>
> [PATCH v2 3/5] selinux: Move sidtab to pointer structure
> Same as for policydb but for sidtab. They are closly related
> and should be switched at the same time.
>
> [PATCH v2 4/5] selinux: Use pointer to switch policydb and sidtab
> Now we can switch rules by switching pointers.
>
> [PATCH v2 5/5] selinux: Switch locking to RCU.
> We are now ready to use RCU.
>
> History: V1 rwsem
>

\
 
 \ /
  Last update: 2018-01-30 14:47    [W:0.378 / U:1.880 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site