lkml.org 
[lkml]   [2018]   [Jan]   [15]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
SubjectRe: [PATCH 3/3] backlight: pwm_bl: don't use GPIOF_* with gpiod_get_direction
From
Date


On 14/01/18 21:07, Wolfram Sang wrote:
> The documentation was wrong, gpiod_get_direction() returns 0/1 instead
> of the GPIOF_* flags. The docs were fixed with commit 94fc73094abe47
> ("gpio: correct docs about return value of gpiod_get_direction"). Now,
> fix this user (until a better, system-wide solution is in place).
>
> Signed-off-by: Wolfram Sang <wsa+renesas@sang-engineering.com>

Acked-by: Daniel Thompson <daniel.thompson@linaro.org>


> ---
> Only build tested!
>
> drivers/video/backlight/pwm_bl.c | 6 +++---
> 1 file changed, 3 insertions(+), 3 deletions(-)
>
> diff --git a/drivers/video/backlight/pwm_bl.c b/drivers/video/backlight/pwm_bl.c
> index 1c2289ddd555a6..0fa7d2bd0e4811 100644
> --- a/drivers/video/backlight/pwm_bl.c
> +++ b/drivers/video/backlight/pwm_bl.c
> @@ -301,14 +301,14 @@ static int pwm_backlight_probe(struct platform_device *pdev)
>
> /*
> * If the GPIO is not known to be already configured as output, that
> - * is, if gpiod_get_direction returns either GPIOF_DIR_IN or -EINVAL,
> - * change the direction to output and set the GPIO as active.
> + * is, if gpiod_get_direction returns either 1 or -EINVAL, change the
> + * direction to output and set the GPIO as active.
> * Do not force the GPIO to active when it was already output as it
> * could cause backlight flickering or we would enable the backlight too
> * early. Leave the decision of the initial backlight state for later.
> */
> if (pb->enable_gpio &&
> - gpiod_get_direction(pb->enable_gpio) != GPIOF_DIR_OUT)
> + gpiod_get_direction(pb->enable_gpio) != 0)
> gpiod_direction_output(pb->enable_gpio, 1);
>
> pb->power_supply = devm_regulator_get(&pdev->dev, "power");
>

\
 
 \ /
  Last update: 2018-01-15 11:14    [W:0.052 / U:0.152 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site