lkml.org 
[lkml]   [2018]   [Jan]   [14]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
Patch in this message
/
From
Subject[PATCH 3/3] backlight: pwm_bl: don't use GPIOF_* with gpiod_get_direction
Date
The documentation was wrong, gpiod_get_direction() returns 0/1 instead
of the GPIOF_* flags. The docs were fixed with commit 94fc73094abe47
("gpio: correct docs about return value of gpiod_get_direction"). Now,
fix this user (until a better, system-wide solution is in place).

Signed-off-by: Wolfram Sang <wsa+renesas@sang-engineering.com>
---
Only build tested!

drivers/video/backlight/pwm_bl.c | 6 +++---
1 file changed, 3 insertions(+), 3 deletions(-)

diff --git a/drivers/video/backlight/pwm_bl.c b/drivers/video/backlight/pwm_bl.c
index 1c2289ddd555a6..0fa7d2bd0e4811 100644
--- a/drivers/video/backlight/pwm_bl.c
+++ b/drivers/video/backlight/pwm_bl.c
@@ -301,14 +301,14 @@ static int pwm_backlight_probe(struct platform_device *pdev)

/*
* If the GPIO is not known to be already configured as output, that
- * is, if gpiod_get_direction returns either GPIOF_DIR_IN or -EINVAL,
- * change the direction to output and set the GPIO as active.
+ * is, if gpiod_get_direction returns either 1 or -EINVAL, change the
+ * direction to output and set the GPIO as active.
* Do not force the GPIO to active when it was already output as it
* could cause backlight flickering or we would enable the backlight too
* early. Leave the decision of the initial backlight state for later.
*/
if (pb->enable_gpio &&
- gpiod_get_direction(pb->enable_gpio) != GPIOF_DIR_OUT)
+ gpiod_get_direction(pb->enable_gpio) != 0)
gpiod_direction_output(pb->enable_gpio, 1);

pb->power_supply = devm_regulator_get(&pdev->dev, "power");
--
2.11.0
\
 
 \ /
  Last update: 2018-01-14 23:27    [W:0.184 / U:0.088 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site