[lkml]   [2017]   [Sep]   [4]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
Messages in this thread
Subject[RESEND PATCH v4 0/2] add thermal nodes for UniPhier SoCs
This series adds thermal nodes for UniPhier PXs2 and LD20 SoCs.

Resending the patches to apply the missing comments,
please ignore previous v4.

Changes since v3:
- use the dt-bindings header to replace the limit values with THERMAL_NO_LIMIT
- add the calibration value to uniphier-pxs2.dtsi
- move the calibration value to uniphier-ld20.dtsi

Changes since v2:
- add the calibration value to device tree for LD20 reference board

Changes since v1:
- separate from driver's patchset[1]
- add cooling-maps nodes on the device tree
- fix an interrupt trigger to set 'level-triggered' according to
hardware specification
- bring up threshold temperature for LD20 according to the spec sheet
- add cpuN labels for reference in cooling-device property on PXs2 dts


Kunihiko Hayashi (2):
ARM: dts: uniphier: add nodes of thermal monitor and thermal zone for
arm64: dts: uniphier: add nodes of thermal monitor and thermal zone
for LD20

arch/arm/boot/dts/uniphier-pxs2.dtsi | 47 ++++++++++++++++++++++--
arch/arm64/boot/dts/socionext/uniphier-ld20.dtsi | 45 +++++++++++++++++++++++
2 files changed, 88 insertions(+), 4 deletions(-)


 \ /
  Last update: 2017-09-04 08:59    [W:0.042 / U:11.712 seconds]
©2003-2018 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site