lkml.org 
[lkml]   [2017]   [Sep]   [1]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
Patch in this message
/
From
Subject[PATCH v2 2/2] ARM: dts: sun8i: h3: Improved Wifi bindings on Bananapi M2 Plus
Date
From: Philipp Rossak <embed3d@gmail.com>

* vqmmc is in this case not needed
* no need for pincontrol nodes when the pin is set to a GPIO

Signed-off-by: Philipp Rossak <embed3d@gmail.com>
---
arch/arm/boot/dts/sun8i-h3-bananapi-m2-plus.dts | 7 -------
1 file changed, 7 deletions(-)

diff --git a/arch/arm/boot/dts/sun8i-h3-bananapi-m2-plus.dts b/arch/arm/boot/dts/sun8i-h3-bananapi-m2-plus.dts
index d756ff8..f7e5d8a 100644
--- a/arch/arm/boot/dts/sun8i-h3-bananapi-m2-plus.dts
+++ b/arch/arm/boot/dts/sun8i-h3-bananapi-m2-plus.dts
@@ -98,7 +98,6 @@
wifi_pwrseq: wifi_pwrseq {
compatible = "mmc-pwrseq-simple";
pinctrl-names = "default";
- pinctrl-0 = <&wifi_en_bpi_m2p>;
reset-gpios = <&r_pio 0 7 GPIO_ACTIVE_LOW>; /* PL7 */
};
};
@@ -153,7 +152,6 @@
pinctrl-names = "default";
pinctrl-0 = <&mmc1_pins_a>;
vmmc-supply = <&reg_vcc3v3>;
- vqmmc-supply = <&reg_vcc3v3>;
mmc-pwrseq = <&wifi_pwrseq>;
bus-width = <4>;
non-removable;
@@ -200,11 +198,6 @@
pins = "PL3";
function = "gpio_in";
};
-
- wifi_en_bpi_m2p: wifi_en_pin {
- pins = "PL7";
- function = "gpio_out";
- };
};

&reg_usb0_vbus {
--
2.7.4
\
 
 \ /
  Last update: 2017-09-01 18:31    [W:0.059 / U:3.608 seconds]
©2003-2017 Jasper Spaans. hosted at Digital OceanAdvertise on this site