lkml.org 
[lkml]   [2017]   [Aug]   [31]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
Date
From
SubjectRe: [PATCH V2] spmi: pmic-arb: Enforce the ownership check optionally
On 08/31, Shawn Guo wrote:
> On Wed, Aug 30, 2017 at 02:02:03PM -0700, Stephen Boyd wrote:
> > On 08/26, Shawn Guo wrote:
> > > On Fri, Aug 25, 2017 at 04:18:18PM -0700, Stephen Boyd wrote:
> > > >
> > > > Right. Does the GPIO work? If so, it sounds like the read/write
> > > > access checks in spmi pmic arb don't work properly.
> > >
> > > The check works. With the check in there, PM8916 GPIO doesn't work.
> > > However, the consequence is that not only user3 but all GPIO leds under
> > > 'leds' node will fail to register, because any GPIO led's failing on
> > > create_gpio_led() makes leds-gpio driver probe fail as a while. That's
> > > how leds-gpio driver works.
> > >
> > > Also, per schematics, PM8916 GPIO1 is indeed routed to user3 LED on
> > > db410c board. Why do you think apq8016-sbc device tree shouldn't use
> > > the GPIO for that at all? Isn't it firmware's fault that the ownership
> > > of the peripheral is not properly configured?
> >
> > If the ownership was not properly configured in the firmware,
> > then I imagine it would mean that we can't control the GPIO for
> > the LED. But that doesn't seem to be true. I can see on my board
> > that I get impermissible write failures on the GPIO when
> > controlling the GPIO brightness, but it doesn't actually matter
> > because the led still lights up. So the checks for write/read
> > permission seem incorrect, or they're not being enforced.
>
> I'm not sure what is happening on your side. As I said above, with the
> 4.13-rc series, leds-gpio driver doesn't probe at all, due to the
> impermissible write to PM8916 GPIO in function create_gpio_led(), and
> none of the LEDs lights up on my board.
>

Yep. I understand all that.

Sorry, I forgot to mention I modified the SPMI PMIC arb code on
v4.13-rc7 to continue even though a permission fault may happen
by deleting the 'return -EPERM' lines. So the LED GPIO driver is
still probing for me, and I see that the GPIOs work regardless of
any permission problems that may have been enforced in the
hardware. I thought the permission checks that the software is
looking at to return EPERM were enforced in hardware, but that
doesn't seem to be the case. That's all I was wondering about.

--
Qualcomm Innovation Center, Inc. is a member of Code Aurora Forum,
a Linux Foundation Collaborative Project

\
 
 \ /
  Last update: 2017-09-01 03:31    [W:0.563 / U:0.620 seconds]
©2003-2017 Jasper Spaans. hosted at Digital OceanAdvertise on this site