lkml.org 
[lkml]   [2017]   [Aug]   [31]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
SubjectRe: [RFC 0/4] mmc: sdhci-msm: Add CQE support for sdhci-msm
From
Date
On 30/08/17 16:04, Ritesh Harjani wrote:
> Hi All,
>
> Please ignore the previous patch series from a wrong email
> address. Stupid gitconfig issue. Apologies for the spam.
>
> This is RFC patch series based on top of ulfh_mmc/cmdq branch
> which is based upon Adrian's CMDQ patch series.
>
> Below patch series enables CQE for sdhci-msm platform.
> This has been tested on internal 8996 MTP which has CMDQ support.
>
> Fixes w.r.t. CMDQ:-
> There are some patches identified which were required atleast on
> MSM platform. I am not sure if these are required for any other
> CQE platform or not. Patchset 1, 3 & 4 commit text describes
> the problems.
>
> Performance related:-
> I gave one small shot for performance and the numbers were not looking good.
> So, unless I have tested for performance completely, I should not discuss
> on performance numbers as of now with this patchset.
> I can try doing some more performance testing and post the results -
> though this may take some while.

You might also need custom Send Status Configuration.

>
> I used below test script for random read/write test.
>
> *randwrite-test-script*
> [global]
> bs=32k
> size=1g
> rw=randwrite
> direct=1
> directory=/data/fiotest

Random write results can vary a lot. It is important to know if the eMMC
has lots of un-mapped blocks or not. e.g. for ext4 is the "-o discard"
option being used. I find I get more consistent results if I always have
discards enabled.

>
> [file1]
> filename=singlefile1
>
> *randread-test-script*
> [global]
> bs=32k
> size=1g
> rw=randread
> directory=/data/fiotest

If you don't set numjobs > 1 then there is little benefit of the queue.
Also still need direct=1

>
> [file1]
> filename=singlefile1
>
> @Adrian,
> Thanks a lot for pursuing and bringing CMDQ patch series to it's final stages :)
>
>
> Ritesh Harjani (4):
> mmc: cqhci: Move CQHCI_ENABLE before setting TDLBA/TDLBAU
> mmc: sdhci-msm: Add CQHCI support for sdhci-msm
> mmc: sdhci-msm: Change the desc_sz on cqe_enable/disable.
> mmc: sdhci-msm: Handle unexpected interrupt case on enabling legacy
> IRQs on CQE halt
>
> .../devicetree/bindings/mmc/sdhci-msm.txt | 1 +
> drivers/mmc/host/Kconfig | 1 +
> drivers/mmc/host/cqhci.c | 7 +-
> drivers/mmc/host/sdhci-msm.c | 121 ++++++++++++++++++++-
> 4 files changed, 125 insertions(+), 5 deletions(-)
>

\
 
 \ /
  Last update: 2017-08-31 10:46    [W:0.078 / U:6.316 seconds]
©2003-2017 Jasper Spaans. hosted at Digital OceanAdvertise on this site