lkml.org 
[lkml]   [2017]   [Aug]   [28]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
Patch in this message
/
Date
From
SubjectRe: [PATCH v8 0/3] PCI: iproc: SOC specific fixes
On Thu, Aug 24, 2017 at 10:34:23AM +0530, Oza Pawandeep wrote:
> PCI: iproc: Retry request when CRS returned from EP Above patch adds
> support for CRS in PCI RC driver, otherwise if not handled at lower
> level, the user space PMD (poll mode drivers) can timeout.
>
> PCI: iproc: add device shutdown for PCI RC This fixes the issue where
> certian PCI endpoints are not getting detected on Stingray SOC after
> reboot.
>
> Changes Since v7:
> Factor out the ep config access code.
>
> Changes Since v6:
> Rebased patches on top of Lorenzo's patches.
> Bjorn's comments addressed.
> now the confg retry returns 0xffffffff as data.
> Added reference to PCIe spec and iproc Controller spec in Changelog.
>
> Changes Since v5:
> Ray's comments addressed.
>
> Changes Since v4:
> Bjorn's comments addressed.
>
> Changes Since v3:
> [re-send]
>
> Changes Since v2:
> Fix compilation errors for pcie-iproc-platform.ko which was caught
> by kbuild.
>
> Oza Pawandeep (3):
> PCI: iproc: factor-out ep configuration access
> PCI: iproc: Retry request when CRS returned from EP
> PCI: iproc: add device shutdown for PCI RC
>
> drivers/pci/host/pcie-iproc-platform.c | 8 ++
> drivers/pci/host/pcie-iproc.c | 143 ++++++++++++++++++++++++++-------
> drivers/pci/host/pcie-iproc.h | 1 +
> 3 files changed, 124 insertions(+), 28 deletions(-)

I applied these to pci/host-iproc for v4.14. Man, this is ugly.

I reworked the changelog to try to make it more readable. I also tried to
disable the PCI_EXP_RTCAP_CRSVIS bit, which advertises CRS SV support. And
I removed what looked like a duplicate pci_generic_config_read32() call.
And I added a warning about the fact that we corrupt reads of config
registers that happen to contain 0xffff0001.

I'm pretty sure I broke something, so please take a look.

Incremental diff from your v8 to what's on pci/host-iproc:

diff --git a/drivers/pci/host/pcie-iproc.c b/drivers/pci/host/pcie-iproc.c
index cbdabe8a073e..8bd5e544b1c1 100644
--- a/drivers/pci/host/pcie-iproc.c
+++ b/drivers/pci/host/pcie-iproc.c
@@ -69,7 +69,7 @@
#define APB_ERR_EN BIT(APB_ERR_EN_SHIFT)

#define CFG_RETRY_STATUS 0xffff0001
-#define CFG_RETRY_STATUS_TIMEOUT_US 500000 /* 500 milli-seconds. */
+#define CFG_RETRY_STATUS_TIMEOUT_US 500000 /* 500 milliseconds */

/* derive the enum index of the outbound/inbound mapping registers */
#define MAP_REG(base_reg, index) ((base_reg) + (index) * 2)
@@ -482,17 +482,21 @@ static unsigned int iproc_pcie_cfg_retry(void __iomem *cfg_data_p)
unsigned int data;

/*
- * As per PCIe spec r3.1, sec 2.3.2, CRS Software
- * Visibility only affects config read of the Vendor ID.
- * For config write or any other config read the Root must
- * automatically re-issue configuration request again as a
- * new request.
+ * As per PCIe spec r3.1, sec 2.3.2, CRS Software Visibility only
+ * affects config reads of the Vendor ID. For config writes or any
+ * other config reads, the Root may automatically reissue the
+ * configuration request again as a new request.
*
- * For config reads, this hardware returns CFG_RETRY_STATUS data when
- * it receives a CRS completion for a config read, regardless of the
- * address of the read or the CRS Software Visibility Enable bit. As a
+ * For config reads, this hardware returns CFG_RETRY_STATUS data
+ * when it receives a CRS completion, regardless of the address of
+ * the read or the CRS Software Visibility Enable bit. As a
* partial workaround for this, we retry in software any read that
* returns CFG_RETRY_STATUS.
+ *
+ * Note that a non-Vendor ID config register may have a value of
+ * CFG_RETRY_STATUS. If we read that, we can't distinguish it from
+ * a CRS completion, so we will incorrectly retry the read and
+ * eventually return the wrong data (0xffffffff).
*/
data = readl(cfg_data_p);
while (data == CFG_RETRY_STATUS && timeout--) {
@@ -515,10 +519,19 @@ static int iproc_pcie_config_read(struct pci_bus *bus, unsigned int devfn,
unsigned int busno = bus->number;
void __iomem *cfg_data_p;
unsigned int data;
+ int ret;

- /* root complex access. */
- if (busno == 0)
- return pci_generic_config_read32(bus, devfn, where, size, val);
+ /* root complex access */
+ if (busno == 0) {
+ ret = pci_generic_config_read32(bus, devfn, where, size, val);
+ if (ret != PCIBIOS_SUCCESSFUL)
+ return ret;
+
+ /* Don't advertise CRS SV support */
+ if ((where & ~0x3) == PCI_EXP_CAP + PCI_EXP_RTCAP)
+ *val &= ~(PCI_EXP_RTCAP_CRSVIS << 16);
+ return PCIBIOS_SUCCESSFUL;
+ }

cfg_data_p = iproc_pcie_map_ep_cfg_reg(pcie, busno, slot, fn, where);

@@ -635,7 +648,6 @@ static int iproc_pcie_config_read32(struct pci_bus *bus, unsigned int devfn,
ret = iproc_pcie_config_read(bus, devfn, where, size, val);
else
ret = pci_generic_config_read32(bus, devfn, where, size, val);
- ret = pci_generic_config_read32(bus, devfn, where, size, val);
iproc_pcie_apb_err_disable(bus, false);

return ret;
@@ -1309,6 +1321,8 @@ static int iproc_pcie_rev_init(struct iproc_pcie *pcie)
pcie->ib.nr_regions = ARRAY_SIZE(paxb_v2_ib_map);
pcie->ib_map = paxb_v2_ib_map;
pcie->need_msi_steer = true;
+ dev_warn(dev, "reads of config registers that contain %#x return incorrect data\n",
+ CFG_RETRY_STATUS);
break;
case IPROC_PCIE_PAXC:
regs = iproc_pcie_reg_paxc;
\
 
 \ /
  Last update: 2017-08-28 23:53    [W:0.156 / U:0.476 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site