lkml.org 
[lkml]   [2017]   [Aug]   [21]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
Date
From
SubjectRe: [PATCH v11 2/4] PCI: Factor out pci_bus_wait_crs()
On Mon, Aug 21, 2017 at 03:37:06PM -0400, Sinan Kaya wrote:
> On 8/21/2017 3:18 PM, Bjorn Helgaas wrote:
> ...
> if (pci_bus_crs_pending(id))
> return pci_bus_wait_crs(dev->bus, dev->devfn, &id, 60000);
>
> > I think that makes sense. We'd want to check for CRS SV being
> > enabled, e.g., maybe read PCI_EXP_RTCTL_CRSSVE back in
> > pci_enable_crs() and cache it somewhere. Maybe a crs_sv_enabled bit
> > in the root port's pci_dev, and check it with something like what
> > pcie_root_rcb_set() does?
> >
>
> You can observe CRS under the following conditions
>
> 1. root port <-> endpoint
> 2. bridge <-> endpoint
> 3. root port<->bridge
>
> I was relying on the fact that we are reading 0x001 as an indication that
> this device detected CRS. Maybe, this is too indirect.
>
> If we also want to capture the capability, I think the right thing is to
> check the parent capability.
>
> bool pci_bus_crs_vis_supported(struct pci_dev *bridge)
> {
> if (device type(bridge) == root port)
> return read(root_crs_register_reg);
>
> if (device type(bridge) == switch)
> return read(switch_crs_register);

I don't understand this part. AFAIK, CRS SV is only a feature of root
ports. The capability and enable bits are in the Root Capabilities
and Root Control registers.

It's certainly true that a device below a switch can respond with a
CRS completion, but the switch is not the requester, and my
understanding is that it would not take any action on the completion
other than passing it upstream.

\
 
 \ /
  Last update: 2017-08-21 22:24    [W:0.106 / U:0.616 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site