lkml.org 
[lkml]   [2017]   [Aug]   [14]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
SubjectRe: [PATCH v6 0/2] Add basic support for Mediatek MT2712 SoC
From
Date


On 08/04/2017 01:59 PM, YT Shen wrote:
> MT2712 is a SoC based on 64bit ARMv8 architecture.
> MT2712 share many HW IP with MT8173. This patchset was tested on MT2712 evaluation board, and boot to shell ok.
>
> This series contains document bindings, device tree including interrupt and uart.
>

pushed to v4.13-next/dts64

Thanks

> Changes compared to v5:
> - remove the soc node
>
> Changes compared to v4:
> - rebase to 4.13-rc1
> - use two clocks (baud_clk & sys_clk) instead of one uart_clk to the correct bindings
>
> Changes compared to v3:
> - use two uart clocks refer to the bindings
>
> Changes compared to v2:
> - remove alias from serial1 to serial5
> - remove initrd-start and initrd-end
> - change GIC_CPU_MASK_SIMPLE(6) to GIC_CPU_MASK_RAW(0x13)
> - change gic-400 reg range
>
> Changes compared to v1:
> - change subject prefix for bindings
> - change device tree license to SPDX tag.
> - change bootargs parameter to DT usage.
> - change intpol-controller to interrupt-controller
>
> YT Shen (2):
> dt-bindings: arm: Add bindings for Mediatek MT2712 SoC Platform
> arm64: dts: Add Mediatek SoC MT2712 and evaluation board dts and
> Makefile
>
> Documentation/devicetree/bindings/arm/mediatek.txt | 4 +
> .../interrupt-controller/mediatek,sysirq.txt | 1 +
> .../devicetree/bindings/serial/mtk-uart.txt | 1 +
> arch/arm64/boot/dts/mediatek/Makefile | 1 +
> arch/arm64/boot/dts/mediatek/mt2712-evb.dts | 32 ++++
> arch/arm64/boot/dts/mediatek/mt2712e.dtsi | 171 +++++++++++++++++++++
> 6 files changed, 210 insertions(+)
> create mode 100644 arch/arm64/boot/dts/mediatek/mt2712-evb.dts
> create mode 100644 arch/arm64/boot/dts/mediatek/mt2712e.dtsi
>

\
 
 \ /
  Last update: 2017-08-14 17:16    [W:0.045 / U:5.348 seconds]
©2003-2017 Jasper Spaans. hosted at Digital OceanAdvertise on this site