lkml.org 
[lkml]   [2017]   [Jul]   [4]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
SubjectRe: [PATCH v4 2/2] PCI: iproc: add device shutdown for PCI RC
From
Date
Hi Oza,

It looks like you missed my comments during the internal review. See my
comments inline below.


On 7/4/2017 8:08 PM, Oza Pawandeep wrote:
> PERST must be asserted around ~500ms before the reboot is applied.
>
> During soft reset (e.g., "reboot" from Linux) on some iproc based SOCs
> LCPLL clock and PERST both goes off simultaneously.
> This will cause certain Endpoints Intel NVMe not get detected, upon
> next boot sequence.
>
> This is specifically happening with Intel P3700 400GB series.
> Endpoint is expecting the clock for some amount of time after PERST is
> asserted, which is not happening in Stingray (iproc based SOC).
> This causes NVMe to behave in undefined way.
>
> On the contrary Intel x86 boards, will have ref clock running, so we
> do not see this behavior there.
>
> Besides, PCI spec does not stipulate about such timings.
> In-fact it does not tell us, whether PCIe device should consider
> refclk to be available or not to be.
>
> It is completely up to vendor to design their EP the way they want
> with respect to ref clock availability.
>
> 500ms is just based on the observation and taken as safe margin.
> This patch adds platform shutdown where it should be
> called in device_shutdown while reboot command is issued.
> So in sequence first Endpoint Shutdown (e.g. nvme_shutdown)
> followed by RC shutdown, which issues safe PERST assertion.
>
> Signed-off-by: Oza Pawandeep <oza.oza@broadcom.com>
> Reviewed-by: Ray Jui <ray.jui@broadcom.com>
> Reviewed-by: Scott Branden <scott.branden@broadcom.com>
>
> diff --git a/drivers/pci/host/pcie-iproc-platform.c b/drivers/pci/host/pcie-iproc-platform.c
> index 90d2bdd..9512960 100644
> --- a/drivers/pci/host/pcie-iproc-platform.c
> +++ b/drivers/pci/host/pcie-iproc-platform.c
> @@ -131,6 +131,13 @@ static int iproc_pcie_pltfm_remove(struct platform_device *pdev)
> return iproc_pcie_remove(pcie);
> }
>
> +static void iproc_pcie_pltfm_shutdown(struct platform_device *pdev)
> +{
> + struct iproc_pcie *pcie = platform_get_drvdata(pdev);
> +
> + iproc_pcie_shutdown(pcie);
> +}
> +
> static struct platform_driver iproc_pcie_pltfm_driver = {
> .driver = {
> .name = "iproc-pcie",
> @@ -138,6 +145,7 @@ static int iproc_pcie_pltfm_remove(struct platform_device *pdev)
> },
> .probe = iproc_pcie_pltfm_probe,
> .remove = iproc_pcie_pltfm_remove,
> + .shutdown = iproc_pcie_pltfm_shutdown,
> };
> module_platform_driver(iproc_pcie_pltfm_driver);
>
> diff --git a/drivers/pci/host/pcie-iproc.c b/drivers/pci/host/pcie-iproc.c
> index b0abcd7..d1bcdc9 100644
> --- a/drivers/pci/host/pcie-iproc.c
> +++ b/drivers/pci/host/pcie-iproc.c
> @@ -616,32 +616,40 @@ static int iproc_pcie_config_write32(struct pci_bus *bus, unsigned int devfn,
> .write = iproc_pcie_config_write32,
> };
>
> -static void iproc_pcie_reset(struct iproc_pcie *pcie)
> +static void iproc_pcie_perst_ctrl(struct iproc_pcie *pcie, bool assert)
> {
> u32 val;
>
> /*
> - * PAXC and the internal emulated endpoint device downstream should not
> - * be reset. If firmware has been loaded on the endpoint device at an
> - * earlier boot stage, reset here causes issues.
> + * The internal emulated endpoints (such as PAXC) device downstream
> + * should not be reset. If firmware has been loaded on the endpoint
> + * device at an earlier boot stage, reset here causes issues.
> */

Why is the above comment modified? Is it even related to this patch that
implements the shutdown routine for PAXB? In addition, the original
comment is more correct. The new comment by stating the "internal
emulated endpoints (such as PAXC)" is wrong. PAXC is not an endpoint.
PAXC is the root complex interface. The endpoint is Nitro.

Thanks,

Ray
> if (pcie->ep_is_internal)
> return;
>
> - /*
> - * Select perst_b signal as reset source. Put the device into reset,
> - * and then bring it out of reset
> - */
> - val = iproc_pcie_read_reg(pcie, IPROC_PCIE_CLK_CTRL);
> - val &= ~EP_PERST_SOURCE_SELECT & ~EP_MODE_SURVIVE_PERST &
> - ~RC_PCIE_RST_OUTPUT;
> - iproc_pcie_write_reg(pcie, IPROC_PCIE_CLK_CTRL, val);
> - udelay(250);
> -
> - val |= RC_PCIE_RST_OUTPUT;
> - iproc_pcie_write_reg(pcie, IPROC_PCIE_CLK_CTRL, val);
> - msleep(100);
> + if (assert) {
> + val = iproc_pcie_read_reg(pcie, IPROC_PCIE_CLK_CTRL);
> + val &= ~EP_PERST_SOURCE_SELECT & ~EP_MODE_SURVIVE_PERST &
> + ~RC_PCIE_RST_OUTPUT;
> + iproc_pcie_write_reg(pcie, IPROC_PCIE_CLK_CTRL, val);
> + udelay(250);
> + } else {
> + val = iproc_pcie_read_reg(pcie, IPROC_PCIE_CLK_CTRL);
> + val |= RC_PCIE_RST_OUTPUT;
> + iproc_pcie_write_reg(pcie, IPROC_PCIE_CLK_CTRL, val);
> + msleep(100);
> + }
> +}
> +
> +int iproc_pcie_shutdown(struct iproc_pcie *pcie)
> +{
> + iproc_pcie_perst_ctrl(pcie, true);
> + msleep(500);
> +
> + return 0;
> }
> +EXPORT_SYMBOL(iproc_pcie_shutdown);
>
> static int iproc_pcie_check_link(struct iproc_pcie *pcie, struct pci_bus *bus)
> {
> @@ -1318,7 +1326,8 @@ int iproc_pcie_setup(struct iproc_pcie *pcie, struct list_head *res)
> goto err_exit_phy;
> }
>
> - iproc_pcie_reset(pcie);
> + iproc_pcie_perst_ctrl(pcie, true);
> + iproc_pcie_perst_ctrl(pcie, false);
>
> if (pcie->need_ob_cfg) {
> ret = iproc_pcie_map_ranges(pcie, res);
> diff --git a/drivers/pci/host/pcie-iproc.h b/drivers/pci/host/pcie-iproc.h
> index 0bbe2ea..a6b55ce 100644
> --- a/drivers/pci/host/pcie-iproc.h
> +++ b/drivers/pci/host/pcie-iproc.h
> @@ -110,6 +110,7 @@ struct iproc_pcie {
>
> int iproc_pcie_setup(struct iproc_pcie *pcie, struct list_head *res);
> int iproc_pcie_remove(struct iproc_pcie *pcie);
> +int iproc_pcie_shutdown(struct iproc_pcie *pcie);
>
> #ifdef CONFIG_PCIE_IPROC_MSI
> int iproc_msi_init(struct iproc_pcie *pcie, struct device_node *node);

\
 
 \ /
  Last update: 2017-07-05 05:52    [W:0.100 / U:0.600 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site