Messages in this thread | | | Subject | Re: [PATCH v4 0/2] Add basic support for Mediatek MT2712 SoC | From | YT Shen <> | Date | Tue, 18 Jul 2017 15:46:02 +0800 |
| |
Hi Matthias,
Just a gentle ping. Should I rebase to 4.13-rc1 and send v5?
Thanks yt.shen
On Thu, 2017-06-22 at 17:32 +0800, YT Shen wrote: > MT2712 is a SoC based on 64bit ARMv8 architecture. > MT2712 share many HW IP with MT8173. This patchset was tested on MT2712 evaluation board, and boot to shell ok. > > This series contains document bindings, device tree including interrupt and uart. > > Changes compared to v3: > - use two uart clocks refer to the bindings > > Changes compared to v2: > - remove alias from serial1 to serial5 > - remove initrd-start and initrd-end > - change GIC_CPU_MASK_SIMPLE(6) to GIC_CPU_MASK_RAW(0x13) > - change gic-400 reg range > > Changes compared to v1: > - change subject prefix for bindings > - change device tree license to SPDX tag. > - change bootargs parameter to DT usage. > - change intpol-controller to interrupt-controller > > YT Shen (2): > dt-bindings: arm: Add bindings for Mediatek MT2712 SoC Platform > arm64: dts: Add Mediatek SoC MT2712 and evaluation board dts and > Makefile > > Documentation/devicetree/bindings/arm/mediatek.txt | 4 + > .../interrupt-controller/mediatek,sysirq.txt | 1 + > .../devicetree/bindings/serial/mtk-uart.txt | 1 + > arch/arm64/boot/dts/mediatek/Makefile | 1 + > arch/arm64/boot/dts/mediatek/mt2712-evb.dts | 32 ++++ > arch/arm64/boot/dts/mediatek/mt2712e.dtsi | 172 +++++++++++++++++++++ > 6 files changed, 211 insertions(+) > create mode 100644 arch/arm64/boot/dts/mediatek/mt2712-evb.dts > create mode 100644 arch/arm64/boot/dts/mediatek/mt2712e.dtsi >
| |