lkml.org 
[lkml]   [2017]   [Jun]   [16]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
SubjectRe: [PATCH v3 0/6] irqchip: meson: add support for the gpio interrupt controller
From
Date
On 15/06/17 17:17, Jerome Brunet wrote:
> This patch series adds support for the GPIO interrupt controller found on
> Amlogic's meson SoC families.
>
> Unlike what the name suggests, this controller is not part of the SoC
> GPIO subsystem. It is a separate controller from which can watch almost
> all pads of the SoC and generate and interrupt from it. Some pins, which
> are not part of the public datasheet, don't seem to have this capability
> though.
>
> Hardware wise, the controller is a 256 to 8 router with filtering block
> to select edge or level input and the polarity of the signal. As there
> we can't setup the filtring to generate a signal on both the high and low
> polarity, there is no easy way to support IRQ_TYPE_EDGE_BOTH at the
> moment
>
> The number of interrupt line routed to the controller depends on the SoC,
> and essentially the number of GPIO available on the SoC.
>
> This series has been tested on Amlogic S905-P200 board with the front
> panel power button.
>
> This work is derived from the previous work of Carlo Caione [1].

[...]

So we have two competing series, all based on the same stuff. I must say
this is rather disappointing that people can't manage to collaborate and
work towards a common goal.

I'm going to review the irqchip part, because I've done that on Heiner's
series as well, but that's where I'm going to stop.

Heiner, Jerome: please sort this out between yourselves *BEFORE* sending
any other patch series. This is wasting everybody's time, both yours and
mine (and frankly, this a rather rare commodity these days).

Thanks,

M.
--
Jazz is not dead. It just smells funny...

\
 
 \ /
  Last update: 2017-06-16 10:46    [W:0.090 / U:0.172 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site