lkml.org 
[lkml]   [2017]   [Jun]   [12]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
SubjectRe: [PATCH v2 2/4] dt: bindings: Add bindings for bcm2835-aux-intc
From
Date
On 06/12/2017 07:25 AM, Phil Elwell wrote:
> Add bindings documentation for brcm,bcm2835-aux-intc and human-readable
> declarations for the BCM2835 AUX IRQs.
>
> Signed-off-by: Phil Elwell <phil@raspberrypi.org>
> ---
> .../interrupt-controller/brcm,bcm2835-aux-intc.txt | 28 ++++++++++++++++++++++
> .../interrupt-controller/bcm2835-aux-intc.h | 20 ++++++++++++++++
> 2 files changed, 48 insertions(+)
> create mode 100644 Documentation/devicetree/bindings/interrupt-controller/brcm,bcm2835-aux-intc.txt
> create mode 100644 include/dt-bindings/interrupt-controller/bcm2835-aux-intc.h
>
> diff --git a/Documentation/devicetree/bindings/interrupt-controller/brcm,bcm2835-aux-intc.txt b/Documentation/devicetree/bindings/interrupt-controller/brcm,bcm2835-aux-intc.txt
> new file mode 100644
> index 0000000..f3f895c
> --- /dev/null
> +++ b/Documentation/devicetree/bindings/interrupt-controller/brcm,bcm2835-aux-intc.txt
> @@ -0,0 +1,28 @@
> +BCM2835 Auxiliary ("AUXIRQ") Interrupt Controller
> +
> +The BCM2835 family of SoCs multiplexes the interrupts for peripherals in
> +the AUX block into a single IRQ. The AUXIRQ register shows the IRQ status
> +of each of the peripherals. Note that there are no masking or clearing
> +facilities - interrupts must be enabled and acknowledged in the
> +individual peripherals.
> +
> +Required properties:
> +- compatible : Should be "brcm,bcm2835-aux-intc".
> +- reg : Specifies base physical address and size of the registers.
> +- interrupts : The interrupt number - see
> + bindings/interrupt-controller/brcm,bcm2835-armctrl-ic.txt
> +- interrupt-controller : Identifies the node as an interrupt controller
> +- #interrupt-cells : Specifies the number of cells needed to encode an
> + interrupt source. The value shall be 1.
> +
> + The cell contains the interrupt specifier, as found in
> + include/dt-bindings/interrupt-controller/bcm2835-aux-intc.h. Valid values
> + are 0..2.

This last sentence is sort of doomed for failure in case there are
additional interrupts being added in the future, referring to
bcm2835-aux-intc.h seems to be good enough IMHO.

Reviewed-by: Florian Fainelli <f.fainelli@gmail.com>
--
Florian

\
 
 \ /
  Last update: 2017-06-12 20:58    [W:0.039 / U:0.384 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site