lkml.org 
[lkml]   [2017]   [May]   [31]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
Date
From
SubjectRe: [PATCH 0/9] Add support for the pin controllers on the Marvell Armada 7K/8K
Hello,

On Fri, 19 May 2017 18:04:42 +0200, Gregory CLEMENT wrote:

> Gregory CLEMENT (6):
> MAINTAINERS: extend mvebu SoC entry with pinctrl drivers
> pinctrl: dt-bindings: add documentation for AP806 pin controllers
> pinctrl: dt-bindings: add documentation for CP110 pin controllers
> pinctrl: mvebu: remove the offset property for regmap
> arm64: marvell: enable the Armada 7K/8K pinctrl driver
> arm64: dts: marvell: add pinctrl support for Armada 7K/8K
>
> Hanna Hawa (2):
> pinctrl: mvebu: add driver for Armada AP806 pinctrl
> pinctrl: mvebu: add driver for Armada CP110 pinctrl
>
> Russell King (1):
> pinctrl: avoid PLAT_ORION dependency

I have tested the combination of your four series (touching clock,
pinmux and gpio) on Armada 8K MacchiatoBin, and I was able to validate
that the CP110 pinmuxing works as expected.

I used MPP37 and MPP38, which I was able to configure as GPIO or I2C0,
and validate that they are working as GPIOs and as I2C0.

I was however unable to test the AP MPPs due to the lack of access to
such pins.

Best regards,

Thomas
--
Thomas Petazzoni, CTO, Free Electrons
Embedded Linux and Kernel engineering
http://free-electrons.com

\
 
 \ /
  Last update: 2017-05-31 11:16    [W:0.155 / U:1.204 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site