Messages in this thread Patch in this message | | | From | Joel Stanley <> | Subject | [PATCH v2 1/2] dt-bindings: reset: Add bindings for basic reset controller | Date | Tue, 30 May 2017 15:38:50 +0930 |
| |
This adds the bindings documentation for a basic single-register reset controller.
The bindings describe a single 32-bit register that contains up to 32 reset lines, each deasserted by clearing the appropriate bit in the register. Optionally a property can be provided that changes this behaviour to assert on clear.
Signed-off-by: Joel Stanley <joel@jms.id.au>
--- V2: Address review from Philipp: - add note about not auto clearing - add property for set to assert behaviour - use a decimal for the bit number
Signed-off-by: Joel Stanley <joel@jms.id.au> --- .../devicetree/bindings/reset/reset-basic.txt | 43 ++++++++++++++++++++++ 1 file changed, 43 insertions(+) create mode 100644 Documentation/devicetree/bindings/reset/reset-basic.txt
diff --git a/Documentation/devicetree/bindings/reset/reset-basic.txt b/Documentation/devicetree/bindings/reset/reset-basic.txt new file mode 100644 index 000000000000..c19e5368be67 --- /dev/null +++ b/Documentation/devicetree/bindings/reset/reset-basic.txt @@ -0,0 +1,43 @@ +Basic single-register reset controller +====================================== + +This describes a generic reset controller where the reset lines are controlled +by single bits within a 32-bit memory location. The memory location is assumed +to be part of a syscon regmap. + +By default the bit will be cleared on deassert. This behaviour can be inverted +with the assert-on-clear property mentioned below. + +The bits are assumed to not be auto-clearing, and therefore can be read back to +determine the status. + +Reset controller required properties: + - compatible: should be "reset-basic" + - #reset-cells: must be set to 1 + - reg: reset register location within regmap + +Reset controller optional properties: + - assert-on-clear: add this property when the hardware should clear (set to 0) + the bit should to assert the reset. + When this property is omitted the default is to set the bit to assert the + reset + +Device node required properties: + - resets phandle + - bit number, counting from zero, for the desired reset line. Max is 31. + +Example: + +syscon { + compatible = "syscon"; + + uart_reset: reset-controller@c { + compatible = "reset-basic"; + #reset-cells = <1>; + reg = <0xc>; + }; +} + +&uart { + resets = <&uart_rest 4>; +} -- 2.11.0
| |