lkml.org 
[lkml]   [2017]   [May]   [18]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
From
Date
SubjectRe: [PATCH v2 6/6] serial: exar: Add support for IOT2040 device
On Thu, May 18, 2017 at 5:59 PM, Jan Kiszka <jan.kiszka@siemens.com> wrote:
> This implements the setup of RS232 and the switch-over to RS485 or RS422
> for the Siemens IOT2040. That uses an EXAR XR17V352 with external logic
> to switch between the different modes. The external logic is controlled
> via MPIO pins of the EXAR controller.
>
> Only pin 10 can be exported as GPIO on the IOT2040. It is connected to
> an LED.
>
> As the XR17V352 used on the IOT2040 is not equipped with an external
> EEPROM, it cannot present itself as IOT2040-variant via subvendor/
> subdevice IDs. Thus, we have to check via DMI for the target platform.
>
> Co-developed with Sascha Weisenberger.

Few nits below and one comment that should be addressed.

> +#define UART_EXAR_RS485_DLY(x) (x << 4)

((x) << 4)

> +static bool is_iot2040;

No, please, use driver data of DMI and hide this in corresponding structure.
Or even assign port->port.rs485_config in the callback function.

Moreover, can't you use port->port.rs485_config != NULL instead?

> +
> struct exar8250;
>
> /**
> @@ -212,6 +252,82 @@ xr17v35x_register_gpio(struct pci_dev *pcidev, unsigned int first_gpio,
> return pdev;
> }
>
> +static int iot2040_rs485_config(struct uart_port *port,
> + struct serial_rs485 *rs485)
> +{
> + u8 __iomem *p = port->membase;
> + u8 mask = IOT2040_UART1_MASK;
> + u8 mode, value;

> + bool is_rs485 = false;
> +
> + if (rs485->flags & SER_RS485_ENABLED) {
> + is_rs485 = true;

bool is_rs485 = !!(rs485->flags & SER_RS485_ENABLED);

if (is_rs485) {
...
} else {
...
}

> + return 0;
> +}

> +static int iot2040_match(const struct dmi_system_id *dmi)
> +{
> + is_iot2040 = true;
> + return 1;
> +}

See above.

> +
> +static const struct dmi_system_id exar_platforms[] = {
> + {
> + .callback = iot2040_match,
> + .ident = "IOT2040",
> + .matches = {
> + DMI_MATCH(DMI_BOARD_NAME, "SIMATIC IOT2000"),
> + DMI_MATCH(DMI_BOARD_ASSET_TAG, "6ES7647-0AA00-1YA2"),
> + },
> + }
> +};

--
With Best Regards,
Andy Shevchenko

\
 
 \ /
  Last update: 2017-05-18 18:34    [W:0.126 / U:0.344 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site