lkml.org 
[lkml]   [2017]   [May]   [12]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
From
Date
SubjectRe: [PATCH v2 1/2] net: Added mtu parameter to dev_forward_skb calls
On Thu, May 11, 2017 at 9:44 PM, Stephen Hemminger
<stephen@networkplumber.org> wrote:
> On Thu, 11 May 2017 21:10:11 +0200
> Fredrik Markström <fredrik.markstrom@gmail.com> wrote:
>
>> On Thu, May 11, 2017 at 6:01 PM, Stephen Hemminger
>> <stephen@networkplumber.org> wrote:
>> > On Thu, 11 May 2017 15:46:27 +0200
>> > Fredrik Markstrom <fredrik.markstrom@gmail.com> wrote:
>> >
>> >> From: Fredrik Markström <fredrik.markstrom@gmail.com>
>> >>
>> >> is_skb_forwardable() currently checks if the packet size is <= mtu of
>> >> the receiving interface. This is not consistent with most of the hardware
>> >> ethernet drivers that happily receives packets larger then MTU.
>> >
>> > Wrong.
>>
>> What is "Wrong" ? I was initially skeptical to implement this patch,
>> since it feels odd to have different MTU:s set on the two sides of a
>> link. After consulting some IP people and the RFC:s I kind of changed
>> my mind and thought I'd give it a shot. In the RFCs I couldn't find
>> anything that defined when and when not a received packet should be
>> dropped.
>>
>> >
>> > Hardware interfaces are free to drop any packet greater than MTU (actually MTU + VLAN).
>> > The actual limit is a function of the hardware. Some hardware can only limit by
>> > power of 2; some can only limit frames larger than 1500; some have no limiting at all.
>>
>> Agreed. The purpose of these patches is to be able to configure an
>> veth interface to mimic these different behaviors. Non of the Ethernet
>> interfaces I have access to drops packets due to them being larger
>> then the configured MTU like veth does.
>>
>> Being able to mimic real Ethernet hardware is useful when
>> consolidating hardware using containers/namespaces.
>>
>> In a reply to a comment from David Miller in my previous version of
>> the patch I attached the example below to demonstrate the case in
>> detail.
>>
>> This works with all ethernet hardware setups I have access to:
>>
>
> Why not just use an iptables rule to enforce what ever semantic you
> want?
>

I think that would be ok, but I can't find anything but TCPMSS but
that's only for TCP.

/Fredrik

\
 
 \ /
  Last update: 2017-05-12 16:37    [W:0.065 / U:0.040 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site