lkml.org 
[lkml]   [2017]   [May]   [10]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
From
Date
SubjectRe: [PATCH v3 2/2] dt-bindings: pcie: Add documentation for Mediatek PCIe
On Wed, May 10, 2017 at 4:07 AM, Ryder Lee <ryder.lee@mediatek.com> wrote:

> +- ranges:
> + - The first three entries are expected to translate the addresses for the root
> + port registers, which are referenced by the assigned-addresses property of
> + the root port nodes (see below).

I don't understand this part. Why do you need a static translation for these?
Shouldn't they just be listed in the 'reg' property of the parent node now that
you have the clk/reset/phy properties in the parent as well?

> +Required properties:
> +- device_type: Must be "pci"
> +- assigned-addresses: Address and size of the port configuration registers
> +- reg: Only the first four bytes are used to refer to the correct bus number
> + and device number.
> +- #address-cells: Must be 3
> +- #size-cells: Must be 2
> +- #interrupt-cells: Must be 1
> +- interrupt-map-mask and interrupt-map: Standard PCI IRQ mapping properties
> + Please refer to the standard PCI bus binding document for a more detailed
> + explanation.

Child nodes do not normally have interrupt-map properties. Isn't this
already covered by the interrupt-map in the parent?

Arnd

\
 
 \ /
  Last update: 2017-05-10 21:21    [W:0.073 / U:0.520 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site