Messages in this thread | | | Subject | Re: [PATCH net-next] bindings: net: stmmac: add missing note about LPI interrupt | From | Sergei Shtylyov <> | Date | Fri, 7 Apr 2017 19:48:16 +0300 |
| |
Hello!
On 04/07/2017 05:30 PM, Niklas Cassel wrote:
> From: Niklas Cassel <niklas.cassel@axis.com> > > The hardware has a LPI interrupt. > There is already code in the stmmac driver to parse and handle the > interrupt. However, this information was missing from the DT binding. > > Signed-off-by: Niklas Cassel <niklas.cassel@axis.com> > --- > Documentation/devicetree/bindings/net/stmmac.txt | 8 ++++---- > 1 file changed, 4 insertions(+), 4 deletions(-) > > diff --git a/Documentation/devicetree/bindings/net/stmmac.txt b/Documentation/devicetree/bindings/net/stmmac.txt > index f652b0c384ce..8977abc266ac 100644 > --- a/Documentation/devicetree/bindings/net/stmmac.txt > +++ b/Documentation/devicetree/bindings/net/stmmac.txt > @@ -8,8 +8,8 @@ Required properties: > that services interrupts for this device > - interrupts: Should contain the STMMAC interrupts > - interrupt-names: Should contain the interrupt names "macirq" > - "eth_wake_irq" if this interrupt is supported in the "interrupts" > - property > + "eth_wake_irq" if this interrupt is supported in the "interrupts property
Missed closing quote?
> + "eth_lpi" if this interrupt is supported in the "interrupts" property > - phy-mode: See ethernet.txt file in the same directory. > - snps,reset-gpio gpio number for phy reset. > - snps,reset-active-low boolean flag to indicate if phy reset is active low. [...]
MBR, Sergei
| |