Messages in this thread Patch in this message | | | From | Bjorn Andersson <> | Subject | [PATCH 2/2] arm64: dts: apq8016-sbc: Correct WLAN LED default-trigger | Date | Wed, 26 Apr 2017 15:04:44 -0700 |
| |
The TX status trigger of the wlan interface is named phy0tx, so this updates the default-trigger for the WLAN LED to use that instead.
Signed-off-by: Bjorn Andersson <bjorn.andersson@linaro.org> ---
Note that without patch 1/2 this trigger does not fire - but there's also no harm in picking the two patches through separate trees.
arch/arm64/boot/dts/qcom/apq8016-sbc.dtsi | 2 +- 1 file changed, 1 insertion(+), 1 deletion(-)
diff --git a/arch/arm64/boot/dts/qcom/apq8016-sbc.dtsi b/arch/arm64/boot/dts/qcom/apq8016-sbc.dtsi index 5d83b02b7c4a..21a8f5ce8955 100644 --- a/arch/arm64/boot/dts/qcom/apq8016-sbc.dtsi +++ b/arch/arm64/boot/dts/qcom/apq8016-sbc.dtsi @@ -178,7 +178,7 @@ led@5 { label = "apq8016-sbc:yellow:wlan"; gpios = <&pm8916_mpps 2 GPIO_ACTIVE_HIGH>; - linux,default-trigger = "wlan"; + linux,default-trigger = "phy0tx"; default-state = "off"; }; -- 2.12.0
| |