lkml.org 
[lkml]   [2017]   [Apr]   [19]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
Patch in this message
/
From
Subject[PATCH 4/4] ARM: sun8i: h3: bananapi-m2-plus: Enable USB OTG
Date
The Bananapi M2 Plus has a USB OTG port that can be used in both
powered host mode and peripheral mode. When in peripheral mode,
the port does not power the board. There is no VBUS sensing on
the port.

This patch adds the regulator controlling VBUS on the OTG port,
the GPIO for the ID detect pin, and enables the USB OTG and host
controllers.

Signed-off-by: Chen-Yu Tsai <wens@csie.org>
---
arch/arm/boot/dts/sun8i-h3-bananapi-m2-plus.dts | 22 +++++++++++++++++++++-
1 file changed, 21 insertions(+), 1 deletion(-)

diff --git a/arch/arm/boot/dts/sun8i-h3-bananapi-m2-plus.dts b/arch/arm/boot/dts/sun8i-h3-bananapi-m2-plus.dts
index 52acbe111cad..17c7c088cdea 100644
--- a/arch/arm/boot/dts/sun8i-h3-bananapi-m2-plus.dts
+++ b/arch/arm/boot/dts/sun8i-h3-bananapi-m2-plus.dts
@@ -92,6 +92,10 @@
};
};

+&ehci0 {
+ status = "okay";
+};
+
&ehci1 {
status = "okay";
};
@@ -145,6 +149,10 @@
status = "okay";
};

+&ohci0 {
+ status = "okay";
+};
+
&ohci1 {
status = "okay";
};
@@ -170,6 +178,11 @@
};
};

+&reg_usb0_vbus {
+ gpio = <&pio 3 11 GPIO_ACTIVE_HIGH>; /* PD11 */
+ status = "okay";
+};
+
&uart0 {
pinctrl-names = "default";
pinctrl-0 = <&uart0_pins_a>;
@@ -182,7 +195,14 @@
status = "okay";
};

+&usb_otg {
+ dr_mode = "otg";
+ status = "okay";
+};
+
&usbphy {
- /* USB VBUS is on as long as VCC-IO is on */
+ usb0_id_det-gpios = <&r_pio 0 6 GPIO_ACTIVE_HIGH>; /* PL6 */
+ usb0_vbus-supply = <&reg_usb0_vbus>;
+ /* USB host VBUS is on as long as VCC-IO is on */
status = "okay";
};
--
2.11.0
\
 
 \ /
  Last update: 2017-04-19 07:11    [W:0.074 / U:0.264 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site