lkml.org 
[lkml]   [2017]   [Apr]   [14]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
SubjectRe: [PATCH V8 4/5] PCI/ASPM: save power on values during bridge init
From
Date
Bjorn,

On 4/12/2017 3:19 PM, Rajat Jain wrote:
> On Fri, Apr 7, 2017 at 9:55 PM, Sinan Kaya <okaya@codeaurora.org> wrote:
>> Now that we added a hook to be called from device_add, save the
>> default values from the HW registers early in the boot for further
>> reuse during hot device add/remove operations.
>>
>> If the link is down during boot, assume that we want to enable L0s
>> and L1 following hotplug insertion as well as L1SS if supported.
>
> IIUC, so far POLICY_DEFAULT meant that we'd just use & follow what
> BIOS has done, and play it safe (never try to be more opportunistic).
> With this change however, we'd be slightly overstepping and giving
> ourselves benefit of doubt if the BIOS could not enable ASPM states
> because the link was not up. This may be good, but I think we should
> call it out, and add some more elaborate comment on the POLICY_DEFAULT
> description (what to, and what not to expect in different situations).
>
> It is important because existing systems today, that used to boot
> without cards and later hotplugged them, didn't have ASPM states
> enabled. They will now suddenly start seeing all ASPM states enabled
> including L1 substates for the first time (if supported).
>

Rajat has a good point here. Would you like me to update the ASPM document
with this new behavior for hotplug?

Do you have another behavior preference when it comes this?

Sinan

--
Sinan Kaya
Qualcomm Datacenter Technologies, Inc. as an affiliate of Qualcomm Technologies, Inc.
Qualcomm Technologies, Inc. is a member of the Code Aurora Forum, a Linux Foundation Collaborative Project.

\
 
 \ /
  Last update: 2017-04-14 21:13    [W:0.203 / U:0.620 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site