Messages in this thread | | | Subject | Re: [PATCH v10 3/3] arm64: dts: exynos: Add support for S6E3HA2 panel device on TM2 board | From | Javier Martinez Canillas <> | Date | Mon, 6 Mar 2017 11:42:04 -0300 |
| |
Hello Hoegeun,
On 02/21/2017 10:09 PM, Hoegeun Kwon wrote: > From: Hyungwon Hwang <human.hwang@samsung.com> > > This patch add the panel device tree node for S6E3HA2 display > controller to TM2 dts. > > Signed-off-by: Hyungwon Hwang <human.hwang@samsung.com> > Signed-off-by: Andrzej Hajda <a.hajda@samsung.com> > Signed-off-by: Chanwoo Choi <cw00.choi@samsung.com> > Signed-off-by: Hoegeun Kwon <hoegeun.kwon@samsung.com> > Tested-by: Chanwoo Choi <cw00.choi@samsung.com> > --- > arch/arm64/boot/dts/exynos/exynos5433-tm2.dts | 12 ++++++++++++ > 1 file changed, 12 insertions(+) > > diff --git a/arch/arm64/boot/dts/exynos/exynos5433-tm2.dts b/arch/arm64/boot/dts/exynos/exynos5433-tm2.dts > index dea0a6f..db3fed2 100644 > --- a/arch/arm64/boot/dts/exynos/exynos5433-tm2.dts > +++ b/arch/arm64/boot/dts/exynos/exynos5433-tm2.dts > @@ -52,6 +52,18 @@ > assigned-clock-rates = <250000000>, <400000000>; > };
I would add a line here.
> +&dsi { > + panel@0 { > + compatible = "samsung,s6e3ha2"; > + reg = <0>; > + vdd3-supply = <&ldo27_reg>; > + vci-supply = <&ldo28_reg>; > + reset-gpios = <&gpg0 0 GPIO_ACTIVE_LOW>; > + enable-gpios = <&gpf1 5 GPIO_ACTIVE_HIGH>; > + te-gpios = <&gpf1 3 GPIO_ACTIVE_HIGH>; > + }; > +}; > +
Reviewed-by: Javier Martinez Canillas <javier@osg.samsung.com>
Best regards, -- Javier Martinez Canillas Open Source Group Samsung Research America
| |