lkml.org 
[lkml]   [2017]   [Mar]   [31]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
SubjectRe: [PATCH v3 0/2] Tango PCIe controller support
From
Date
On 30/03/2017 22:56, Mason wrote:

> I've run into an issue.
>
> If I boot the system with earlyprintk enabled (as I've
> been doing throughout my dev), things work as expected.
>
> But if I boot with earlyprintk disabled, then the system
> does not "see" the PCIe board, because reading the vendor
> ID returns 0xffffffff.
>
> What we think is happening, is that when earlyprintk is
> disabled, the system proceeds much faster through the
> various inits, and the PCIe init happens when PCIe
> link training has not completed yet.
>
> If that is the case, then it seems I would need to check
> the link state in my probe function.

I determined empirically that link training takes around
10-15 ms. Though I suppose this might depend on the
specific PCIe board? (I'm only considering x1 link.)

So I added an msleep(20); in the probe function, and in
the config_read callback, I check the link status on the
first read to the device.

Should I msleep(40) to be safe?

Regards.

\
 
 \ /
  Last update: 2017-04-01 00:06    [W:0.279 / U:0.388 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site