lkml.org 
[lkml]   [2017]   [Mar]   [17]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
Patch in this message
/
From
Subject[PATCH 1/5] dt-bindings: i2c-stm32: Document the STM32F7 I2C bindings
Date
This patch adds the documentation of device tree bindings for STM32F7 I2C

Signed-off-by: M'boumba Cedric Madianga <cedric.madianga@gmail.com>
---
.../devicetree/bindings/i2c/i2c-stm32.txt | 22 +++++++++++++++++++---
1 file changed, 19 insertions(+), 3 deletions(-)

diff --git a/Documentation/devicetree/bindings/i2c/i2c-stm32.txt b/Documentation/devicetree/bindings/i2c/i2c-stm32.txt
index 78eaf7b..8288724 100644
--- a/Documentation/devicetree/bindings/i2c/i2c-stm32.txt
+++ b/Documentation/devicetree/bindings/i2c/i2c-stm32.txt
@@ -1,7 +1,9 @@
* I2C controller embedded in STMicroelectronics STM32 I2C platform

Required properties :
-- compatible : Must be "st,stm32f4-i2c"
+- compatible : Must be one of the following
+ - "st,stm32f4-i2c"
+ - "st,stm32f7-i2c"
- reg : Offset and length of the register set for the device
- interrupts : Must contain the interrupt id for I2C event and then the
interrupt id for I2C error.
@@ -14,8 +16,22 @@ Required properties :

Optional properties :
- clock-frequency : Desired I2C bus clock frequency in Hz. If not specified,
- the default 100 kHz frequency will be used. As only Normal and Fast modes
- are supported, possible values are 100000 and 400000.
+ the default 100 kHz frequency will be used.
+ For STM32F4 SoC Standard-mode and Fast-mode are supported, possible values are
+ 100000 and 400000.
+ For STM32F7 SoC, Standard-mode, Fast-mode and Fast-mode Plus are supported,
+ possible values are 100000, 400000 and 1000000.
+- st,i2c-timing : A 32-bit I2C timing refister value.
+ This value is only required for "st,stm32f7-i2c".
+ A specific external tool delivered by ST is used to compute the value to be
+ set here according to i2C speed frequency, i2c clock source frequency,
+ i2c rise time and i2c fall time inputs.
+ - bit 31:28: PRESC[3:0]: Timing prescaler
+ - bit 27:24: Reserved
+ - bit 23:20: SCLDEL[3:0]: Data setup time
+ - bit 19:16: SDADEL[3:0]: Data hold time
+ - bit 15:8: SCLH[7:0]: SCL high period
+ - bit 7:0: SCLL[7:0]: SCL low period

Example :

--
1.9.1
\
 
 \ /
  Last update: 2017-03-17 11:01    [W:0.126 / U:0.128 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site