lkml.org 
[lkml]   [2017]   [Mar]   [13]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
Patch in this message
/
From
Subject[PATCH 1/2] net: davinci_mdio: add GPIO reset logic
Date
Some boards [1] leave the PHYs at an invalid state
during system power-up or reset thus causing unreliability
issues with the PHY like not being detected by the mdio bus
or link not functional. To work around these boards have
a GPIO connected to the PHY's reset pin.

Implement GPIO reset handling for such cases.

[1] - am572x-idk, am571x-idk, a437x-idk.

Signed-off-by: Roger Quadros <rogerq@ti.com>
Signed-off-by: Sekhar Nori <nsekhar@ti.com>
---
.../devicetree/bindings/net/davinci-mdio.txt | 2 +
drivers/net/ethernet/ti/davinci_mdio.c | 68 +++++++++++++++++++---
2 files changed, 62 insertions(+), 8 deletions(-)

diff --git a/Documentation/devicetree/bindings/net/davinci-mdio.txt b/Documentation/devicetree/bindings/net/davinci-mdio.txt
index 621156c..fd6ebe7 100644
--- a/Documentation/devicetree/bindings/net/davinci-mdio.txt
+++ b/Documentation/devicetree/bindings/net/davinci-mdio.txt
@@ -12,6 +12,8 @@ Required properties:

Optional properties:
- ti,hwmods : Must be "davinci_mdio"
+- reset-gpios : array of GPIO specifier for PHY hardware reset control
+- reset-delay-us : reset assertion time [in microseconds]

Note: "ti,hwmods" field is used to fetch the base address and irq
resources from TI, omap hwmod data base during device registration.
diff --git a/drivers/net/ethernet/ti/davinci_mdio.c b/drivers/net/ethernet/ti/davinci_mdio.c
index 33df340..c6f9e55 100644
--- a/drivers/net/ethernet/ti/davinci_mdio.c
+++ b/drivers/net/ethernet/ti/davinci_mdio.c
@@ -40,6 +40,9 @@
#include <linux/of_device.h>
#include <linux/of_mdio.h>
#include <linux/pinctrl/consumer.h>
+#include <linux/gpio.h>
+#include <linux/gpio/consumer.h>
+#include <linux/of_gpio.h>

/*
* This timeout definition is a worst-case ultra defensive measure against
@@ -53,6 +56,8 @@

#define DEF_OUT_FREQ 2200000 /* 2.2 MHz */

+#define DEFAULT_GPIO_RESET_DELAY 10 /* in microseconds */
+
struct davinci_mdio_of_param {
int autosuspend_delay_ms;
};
@@ -104,6 +109,9 @@ struct davinci_mdio_data {
*/
bool skip_scan;
u32 clk_div;
+ struct gpio_desc **gpio_reset;
+ int num_gpios;
+ int reset_delay_us;
};

static void davinci_mdio_init_clk(struct davinci_mdio_data *data)
@@ -142,6 +150,20 @@ static void davinci_mdio_enable(struct davinci_mdio_data *data)
__raw_writel(data->clk_div | CONTROL_ENABLE, &data->regs->control);
}

+static void __davinci_gpio_reset(struct davinci_mdio_data *data)
+{
+ int i;
+
+ for (i = 0; i < data->num_gpios; i++) {
+ if (!data->gpio_reset[i])
+ continue;
+
+ gpiod_set_value_cansleep(data->gpio_reset[i], 1);
+ udelay(data->reset_delay_us);
+ gpiod_set_value_cansleep(data->gpio_reset[i], 0);
+ }
+}
+
static int davinci_mdio_reset(struct mii_bus *bus)
{
struct davinci_mdio_data *data = bus->priv;
@@ -317,20 +339,50 @@ static int davinci_mdio_write(struct mii_bus *bus, int phy_id,
}

#if IS_ENABLED(CONFIG_OF)
-static int davinci_mdio_probe_dt(struct mdio_platform_data *data,
- struct platform_device *pdev)
+static int davinci_mdio_probe_dt(struct davinci_mdio_data *data,
+ struct platform_device *pdev)
{
struct device_node *node = pdev->dev.of_node;
u32 prop;
-
- if (!node)
- return -EINVAL;
+ int error;
+ int i;
+ struct gpio_desc *gpiod;

if (of_property_read_u32(node, "bus_freq", &prop)) {
dev_err(&pdev->dev, "Missing bus_freq property in the DT.\n");
- return -EINVAL;
+ data->pdata = default_pdata;
+ } else {
+ data->pdata.bus_freq = prop;
+ }
+
+ i = of_gpio_named_count(node, "reset-gpios");
+ if (i > 0) {
+ data->num_gpios = i;
+ data->gpio_reset = devm_kcalloc(&pdev->dev, i,
+ sizeof(struct gpio_desc *),
+ GFP_KERNEL);
+ if (!data->gpio_reset)
+ return -ENOMEM;
+
+ for (i = 0; i < data->num_gpios; i++) {
+ gpiod = devm_gpiod_get_index(&pdev->dev, "reset", i,
+ GPIOD_OUT_LOW);
+ if (IS_ERR(gpiod)) {
+ error = PTR_ERR(gpiod);
+ if (error == -ENOENT)
+ continue;
+ else
+ return error;
+ }
+ data->gpio_reset[i] = gpiod;
+ }
+
+ if (of_property_read_u32(node, "reset-delay-us",
+ &data->reset_delay_us))
+ data->reset_delay_us = DEFAULT_GPIO_RESET_DELAY;
+
+ __davinci_gpio_reset(data);
}
- data->bus_freq = prop;

return 0;
}
@@ -372,7 +424,7 @@ static int davinci_mdio_probe(struct platform_device *pdev)
if (dev->of_node) {
const struct of_device_id *of_id;

- ret = davinci_mdio_probe_dt(&data->pdata, pdev);
+ ret = davinci_mdio_probe_dt(data, pdev);
if (ret)
return ret;
snprintf(data->bus->id, MII_BUS_ID_SIZE, "%s", pdev->name);
--
2.7.4
\
 
 \ /
  Last update: 2017-03-13 14:43    [W:0.142 / U:0.912 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site