lkml.org 
[lkml]   [2017]   [Feb]   [6]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
Patch in this message
/
From
Subject[PATCH 2/2] spi: davinci: enable DMA when channels are defined in DT
Date
When booting with DT the SPI driver is always using
the SPI_IO_TYPE_INTR mode to transfer data even if DMA channels are
defined in the DT.

This commit changes the behaviour to select the SPI_IO_TYPE_DMA mode
if DMA channels are defined in the DT and will keep SPI_IO_TYPE_INTR
if the channels are not defined in it.

Signed-off-by: Fabien Parent <fparent@baylibre.com>
---
drivers/spi/spi-davinci.c | 4 ++++
1 file changed, 4 insertions(+)

diff --git a/drivers/spi/spi-davinci.c b/drivers/spi/spi-davinci.c
index cb80c1d3f86a..b73072ae8adb 100644
--- a/drivers/spi/spi-davinci.c
+++ b/drivers/spi/spi-davinci.c
@@ -389,6 +389,7 @@ static int davinci_spi_of_setup(struct spi_device *spi)
{
struct davinci_spi_config *spicfg = spi->controller_data;
struct device_node *np = spi->dev.of_node;
+ struct davinci_spi *dspi = spi_master_get_devdata(spi->master);
u32 prop;

if (spicfg == NULL && np) {
@@ -400,6 +401,9 @@ static int davinci_spi_of_setup(struct spi_device *spi)
if (!of_property_read_u32(np, "ti,spi-wdelay", &prop))
spicfg->wdelay = (u8)prop;
spi->controller_data = spicfg;
+
+ if (dspi->dma_rx && dspi->dma_tx)
+ spicfg->io_type = SPI_IO_TYPE_DMA;
}

return 0;
--
2.11.0
\
 
 \ /
  Last update: 2017-02-06 15:58    [W:0.056 / U:0.052 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site