lkml.org 
[lkml]   [2017]   [Feb]   [3]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
Patch in this message
/
Date
From
Subject[PATCH] devicetree: Add video bus switch

N900 contains front and back camera, with a switch between the
two. This adds support for the switch component, and it is now
possible to select between front and back cameras during runtime.

This adds documentation for the devicetree binding.

Signed-off-by: Sebastian Reichel <sre@kernel.org>
Signed-off-by: Ivaylo Dimitrov <ivo.g.dimitrov.75@gmail.com>
Signed-off-by: Pavel Machek <pavel@ucw.cz>


diff --git a/Documentation/devicetree/bindings/media/video-bus-switch.txt b/Documentation/devicetree/bindings/media/video-bus-switch.txt
new file mode 100644
index 0000000..1b9f8e0
--- /dev/null
+++ b/Documentation/devicetree/bindings/media/video-bus-switch.txt
@@ -0,0 +1,63 @@
+Video Bus Switch Binding
+========================
+
+This is a binding for a gpio controlled switch for camera interfaces. Such a
+device is used on some embedded devices to connect two cameras to the same
+interface of a image signal processor.
+
+Required properties
+===================
+
+compatible : must contain "video-bus-switch"
+switch-gpios : GPIO specifier for the gpio, which can toggle the
+ selected camera. The GPIO should be configured, so
+ that a disabled GPIO means, that the first port is
+ selected.
+
+Required Port nodes
+===================
+
+More documentation on these bindings is available in
+video-interfaces.txt in the same directory.
+
+reg : The interface:
+ 0 - port for image signal processor
+ 1 - port for first camera sensor
+ 2 - port for second camera sensor
+
+Example
+=======
+
+video-bus-switch {
+ compatible = "video-bus-switch"
+ switch-gpios = <&gpio1 1 GPIO_ACTIVE_HIGH>;
+
+ ports {
+ #address-cells = <1>;
+ #size-cells = <0>;
+
+ port@0 {
+ reg = <0>;
+
+ csi_switch_in: endpoint {
+ remote-endpoint = <&csi_isp>;
+ };
+ };
+
+ port@1 {
+ reg = <1>;
+
+ csi_switch_out1: endpoint {
+ remote-endpoint = <&csi_cam1>;
+ };
+ };
+
+ port@2 {
+ reg = <2>;
+
+ csi_switch_out2: endpoint {
+ remote-endpoint = <&csi_cam2>;
+ };
+ };
+ };
+};


--
(english) http://www.livejournal.com/~pavelmachek
(cesky, pictures) http://atrey.karlin.mff.cuni.cz/~pavel/picture/horses/blog.html
[unhandled content-type:application/pgp-signature]
\
 
 \ /
  Last update: 2017-02-03 13:35    [W:0.292 / U:1.008 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site