lkml.org 
[lkml]   [2017]   [Feb]   [27]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
Patch in this message
/
From
Subject[PATCH] serial: 8250_dw: Honor clk_round_rate errors in dw8250_set_termios
Date
clk_round_rate returns a signed long and may possibly return errors
in it, for example if there is no possible rate.

Till now dw8250_set_termios ignored any error, the signednes and would
just use the value as input to clk_set_rate. This of course falls apart
if there is an actual error, so check for errors and only try to set
a rate if the value is actually valid.

Signed-off-by: Heiko Stuebner <heiko@sntech.de>
---
drivers/tty/serial/8250/8250_dw.c | 7 +++++--
1 file changed, 5 insertions(+), 2 deletions(-)

diff --git a/drivers/tty/serial/8250/8250_dw.c b/drivers/tty/serial/8250/8250_dw.c
index 6ee55a2d47bb..223ac234ddb2 100644
--- a/drivers/tty/serial/8250/8250_dw.c
+++ b/drivers/tty/serial/8250/8250_dw.c
@@ -257,7 +257,7 @@ static void dw8250_set_termios(struct uart_port *p, struct ktermios *termios,
{
unsigned int baud = tty_termios_baud_rate(termios);
struct dw8250_data *d = p->private_data;
- unsigned int rate;
+ long rate;
int ret;

if (IS_ERR(d->clk) || !old)
@@ -265,7 +265,10 @@ static void dw8250_set_termios(struct uart_port *p, struct ktermios *termios,

clk_disable_unprepare(d->clk);
rate = clk_round_rate(d->clk, baud * 16);
- ret = clk_set_rate(d->clk, rate);
+ if (rate < 0)
+ ret = rate;
+ else
+ ret = clk_set_rate(d->clk, rate);
clk_prepare_enable(d->clk);

if (!ret)
--
2.11.0
\
 
 \ /
  Last update: 2017-02-28 05:31    [W:0.091 / U:0.308 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site