lkml.org 
[lkml]   [2017]   [Feb]   [21]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
SubjectRe: [PATCH/RFC 4/6] drivers: firmware: psci: Fix non-PMIC wake-up if SYSTEM_SUSPEND cuts power
From
Date
Hi Geert,

On 21/02/17 16:36, Geert Uytterhoeven wrote:
> Hi Sudeep,
>
> On Tue, Feb 21, 2017 at 11:50 AM, Sudeep Holla <sudeep.holla@arm.com> wrote:
>> On 20/02/17 20:33, Geert Uytterhoeven wrote:
>>> Nothing in the PSCI specification requires the SoC to remain powered and
>>> to support wake-up sources when suspended using SYSTEM_SUSPEND.
>>> If the firmware implements the PSCI SYSTEM_SUSPEND operation by cutting
>>> power to the SoC, the only possibly wake-up sources are thus the ones
>>> connected to the PMIC.
>>>
>>> Document and add support for an "arm,psci-system-suspend-is-power-down"
>>> DT property, so Linux uses a different suspend method when other wake-up
>>> sources (e.g. wake on LAN, UART or GPIO) are enabled.
>>>
>>> Signed-off-by: Geert Uytterhoeven <geert+renesas@glider.be>
>>> ---
>>> Documentation/devicetree/bindings/arm/psci.txt | 11 +++++++++++
>>> drivers/firmware/psci.c | 13 ++++++++++---
>>> 2 files changed, 21 insertions(+), 3 deletions(-)
>>>
>>> diff --git a/Documentation/devicetree/bindings/arm/psci.txt b/Documentation/devicetree/bindings/arm/psci.txt
>>> index a2c4f1d524929bb7..16e390ecb7531028 100644
>>> --- a/Documentation/devicetree/bindings/arm/psci.txt
>>> +++ b/Documentation/devicetree/bindings/arm/psci.txt
>>> @@ -68,6 +68,17 @@ state nodes, as per bindings in [1]) must specify the following properties:
>>> Definition: power_state parameter to pass to the PSCI
>>> suspend call.
>>>
>>> + - arm,psci-system-suspend-is-power-down
>>> + Nothing in the PSCI specification requires the SoC to remain
>>> + powered and to support wake-up sources when suspended using
>>> + SYSTEM_SUSPEND.
>>
>> Again, yes SoC can be powered down but you give no reasons why this is
>> useful other than help you to hack around to implement suspend_ops. As
>
> This is useful to support other wake-up sources. Linux has a standardized
> way to handle wake-up sources, which may be circumvented by calling PSCI
> SYSTEM_SUSPEND.
>
>> suggested please try using freeze_ops.
>
> Freezing the system works, but requires manual configurarion.
> This should be done automatically.
>

What sort of manual configuration ? I am just asking to understand you
setup better.

>> After commit a94e502c22b6 ("cpuidle: dt: assign ->enter_freeze to same
>> as ->enter callback function"), you can enter suspend-to-idle(a.k.a
>> freeze state) on all platforms using ARM DT cpuidle driver.
>
> This should be used automatically if the system can't wake-up from
> suspend-to-RAM using the configured wake-up sources.
>

Yes.

--
Regards,
Sudeep

\
 
 \ /
  Last update: 2017-02-21 17:49    [W:0.114 / U:0.204 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site