Messages in this thread | | | Date | Thu, 2 Feb 2017 16:22:12 +0100 | From | Lukasz Majewski <> | Subject | Re: [PATCH] net: phy: dp83867: Port mirroring support in the DP83867 TI's PHY driver |
| |
On Thu, 2 Feb 2017 14:11:12 +0100 Andrew Lunn <andrew@lunn.ch> wrote:
> > The bootstrapping process in the PHY sets this bit. This is wrong > > since the board lane layout is not "swapped" > > Ah, you mean a strapping pin? Resistor to ground/VCC?
Yes, exactly.
> That is a different matter. It makes it a lot less likely to break > some existing board with such a change. > > > I have thought a bit about that and I think that we should define > > complementary "net-phy-lane-no-swap" as suggested by Florian. Then > > affected boards could define it and use. > > This is the most flexible solution. Yes, that is O.K. for me.
Ok. thanks.
> > Andrew
Best regards,
Lukasz Majewski
--
DENX Software Engineering GmbH, Managing Director: Wolfgang Denk HRB 165235 Munich, Office: Kirchenstr.5, D-82194 Groebenzell, Germany Phone: (+49)-8142-66989-10 Fax: (+49)-8142-66989-80 Email: wd@denx.de
| |