lkml.org 
[lkml]   [2017]   [Dec]   [20]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
Patch in this message
/
From
Subject[PATCH] net: phy: micrel: ksz9031: reconfigure autoneg after phy autoneg workaround
Date
Under some circumstances driver will perform PHY reset in
ksz9031_read_status() to fix autoneg failure case (idle error count =
0xFF). When this happens ksz9031 will not detect link status change any
more when connecting to Netgear 1G switch (link can be recovered sometimes by
restarting netdevice "ifconfig down up"). Reproduced with TI am572x board
equipped with ksz9031 PHY while connecting to Netgear 1G switch.

Fix the issue by reconfiguring autonegotiation after PHY reset in
ksz9031_read_status().

Fixes: d2fd719bcb0e ("net/phy: micrel: Add workaround for bad autoneg")
Signed-off-by: Grygorii Strashko <grygorii.strashko@ti.com>
---
drivers/net/phy/micrel.c | 1 +
1 file changed, 1 insertion(+)

diff --git a/drivers/net/phy/micrel.c b/drivers/net/phy/micrel.c
index ab46141..422ff63 100644
--- a/drivers/net/phy/micrel.c
+++ b/drivers/net/phy/micrel.c
@@ -624,6 +624,7 @@ static int ksz9031_read_status(struct phy_device *phydev)
phydev->link = 0;
if (phydev->drv->config_intr && phy_interrupt_is_valid(phydev))
phydev->drv->config_intr(phydev);
+ return genphy_config_aneg(phydev);
}

return 0;
--
2.10.5
\
 
 \ /
  Last update: 2017-12-21 01:46    [W:0.068 / U:0.124 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site