Messages in this thread | | | Date | Wed, 20 Dec 2017 00:55:27 +0100 | From | Niklas Cassel <> | Subject | Re: [PATCH v5 01/18] PCI: dwc: Use the DMA-API to get the MSI address |
| |
On Tue, Dec 19, 2017 at 12:45:30PM +0000, Gustavo Pimentel wrote: > Tested-By: Gustavo Pimentel <gustavo.pimentel@synopsys.com> > > Using an arc board with USB and SATA end points with a root complex PCIe IP core > version 5.00, I ran the the following tests: > - I checked that all end points were listed correctly; > - I checked that no PCI related errors was present in dmesg; > - I copied a file from arc to the USB flash drive and checked the checksum; > - I copied a file from USB flash drive to the ARC and checked the checksum; > - I copied a file from arc to the SATA disk and checked the checksum; > - I copied a file from SATA disk to the arc and checked the checksum; > - I copied a file from USB flash drive to the SATA disk and checked the checksum; > - I copied a file from SATA disk to the USB flash drive and checked the checksum; > - I checked that no PCI related errors was present in dmesg; > > Everything seemed normal to me.
Hello Gustavo,
Thanks a lot for testing.
FYI: I submitted a new patch set to address Lorenzo's review comments, however, I do not think that we need to redo all the testing, since now we are using the same GFP flags for MSI as we did before, which obviously worked.
https://marc.info/?l=devicetree&m=151372652827788&w=2
Regards, Niklas
| |