lkml.org 
[lkml]   [2017]   [Dec]   [15]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
From
Subject[RFC 0/5] IR support for A83T - sunxi-ir driver update
Date
This patch series adds support for the sunxi A83T ir module and enhances the sunxi-ir driver.
Right now the base clock frequency for the ir driver is a hard coded define and is set to 8 MHz.
This works for the most common ir receivers. On the Sinovoip Bananapi M3 the ir receiver needs,
a 3 MHz base clock frequency to work without problems with this driver (like in the legacy kernel).

To fix this issue I reworked the driver that this value could be set over the devicetree.

About 37 devices would have a devicetree change if this patch series would be applied.
Therfore I would like to ask you to give me some feedback about the patch series, before I finialize it.


Thanks in advance!

Philipp


Philipp Rossak (5):
[media] rc: update sunxi-ir driver to get base frequency from
devicetree
[media] dt: bindings: Update binding documentation for sunxi IR
controller
ARM: dts: sun8i: a83t: Add the ir pin for the A83T
ARM: dts: sun8i: a83t: Add support for the ir interface
ARM: dts: sun8i: a83t: bananapi-m3: Enable IR controller

Documentation/devicetree/bindings/media/sunxi-ir.txt | 14 ++++++++------
arch/arm/boot/dts/sun8i-a83t-bananapi-m3.dts | 7 +++++++
arch/arm/boot/dts/sun8i-a83t.dtsi | 15 +++++++++++++++
drivers/media/rc/sunxi-cir.c | 20 +++++++++++---------
4 files changed, 41 insertions(+), 15 deletions(-)

--
2.11.0

\
 
 \ /
  Last update: 2017-12-16 03:51    [W:1.601 / U:0.072 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site