lkml.org 
[lkml]   [2017]   [Dec]   [12]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
Patch in this message
/
SubjectRe: [PATCH] ARC: Force disable IOC if ioc_enable=0
From
Date
On 12/05/2017 02:19 AM, Alexey Brodkin wrote:
> U-Boot enables and uses IOC so if we don't want to use it in the kernel
> we need to _disable_ it for real. This is in comparison to what we do
> today based on "ioc_enable" flag - if it is set to 0 we just
> _dont_enable_ IOC which effectively keeps IOC alive and kicking.
>
> Signed-off-by: Alexey Brodkin <abrodkin@synopsys.com>
> ---
> arch/arc/mm/cache.c | 47 +++++++++++++++++++++++++++--------------------
> 1 file changed, 27 insertions(+), 20 deletions(-)
>
> diff --git a/arch/arc/mm/cache.c b/arch/arc/mm/cache.c
> index eee924dfffa6..b763c34aa6bc 100644
> --- a/arch/arc/mm/cache.c
> +++ b/arch/arc/mm/cache.c
> @@ -1149,6 +1149,10 @@ noinline void __init arc_ioc_setup(void)
> {
> unsigned int ioc_base, mem_sz;
>
> + /* Force disable IOC if it exists but we don't want to use it */
> + if (ioc_exists && !ioc_enable)
> + write_aux_reg(ARC_REG_IO_COH_ENABLE, 0);
> +

Hmm this routine is NOT even called if ioc_enable is 0. See arc_cache_init_master()

    if (is_isa_arcv2() && ioc_enable)
        arc_ioc_setup();

So better to write another function for disabling - just like we do for SLC.

Anyhow that's the mechanics. In terms of actual code

1. Should we do this if coh was actually enabled by bootloader / pre-bootloader -
by reading out the existing value of COH_ENABLE aux register ?

2. Do we need to make sure that there are no D$ snoop transactions in flight while
doing this. Although slave cores would likely be halted (or spinning on uncached
flag) still if this is done, it would be preferable to do this under
__dc_disable() to make sure any prior in-flight snoop transactions settle down.



> /* Flush + invalidate + disable L1 dcache */
> __dc_disable();
>
> @@ -1156,31 +1160,34 @@ noinline void __init arc_ioc_setup(void)
> if (read_aux_reg(ARC_REG_SLC_BCR))
> slc_entire_op(OP_FLUSH_N_INV);
>
> - /*
> - * currently IOC Aperture covers entire DDR
> - * TBD: fix for PGU + 1GB of low mem
> - * TBD: fix for PAE
> - */
> - mem_sz = arc_get_mem_sz();
> + /* Only setup IOC if we really want to use it */
> + if (ioc_exists && ioc_enable) {

Only checking for ioc_enable suffices since read_decode_cache_bcr_arcv2() ensures
it is (re)set 0 if ioc_exists == 0

> + /*
> + * currently IOC Aperture covers entire DDR
> + * TBD: fix for PGU + 1GB of low mem
> + * TBD: fix for PAE
> + */
> + mem_sz = arc_get_mem_sz();
>
> - if (!is_power_of_2(mem_sz) || mem_sz < 4096)
> - panic("IOC Aperture size must be power of 2 larger than 4KB");
> + if (!is_power_of_2(mem_sz) || mem_sz < 4096)
> + panic("IOC Aperture size must be power of 2 larger than 4KB");
>
> - /*
> - * IOC Aperture size decoded as 2 ^ (SIZE + 2) KB,
> - * so setting 0x11 implies 512MB, 0x12 implies 1GB...
> - */
> - write_aux_reg(ARC_REG_IO_COH_AP0_SIZE, order_base_2(mem_sz >> 10) - 2);
> + /*
> + * IOC Aperture size decoded as 2 ^ (SIZE + 2) KB,
> + * so setting 0x11 implies 512MB, 0x12 implies 1GB...
> + */
> + write_aux_reg(ARC_REG_IO_COH_AP0_SIZE, order_base_2(mem_sz >> 10) - 2);
>
> - /* for now assume kernel base is start of IOC aperture */
> - ioc_base = CONFIG_LINUX_RAM_BASE;
> + /* for now assume kernel base is start of IOC aperture */
> + ioc_base = CONFIG_LINUX_RAM_BASE;
>
> - if (ioc_base % mem_sz != 0)
> - panic("IOC Aperture start must be aligned to the size of the aperture");
> + if (ioc_base % mem_sz != 0)
> + panic("IOC Aperture start must be aligned to the size of the aperture");
>
> - write_aux_reg(ARC_REG_IO_COH_AP0_BASE, ioc_base >> 12);
> - write_aux_reg(ARC_REG_IO_COH_PARTIAL, 1);
> - write_aux_reg(ARC_REG_IO_COH_ENABLE, 1);
> + write_aux_reg(ARC_REG_IO_COH_AP0_BASE, ioc_base >> 12);
> + write_aux_reg(ARC_REG_IO_COH_PARTIAL, 1);
> + write_aux_reg(ARC_REG_IO_COH_ENABLE, 1);
> + }
>
> /* Re-enable L1 dcache */
> __dc_enable();

\
 
 \ /
  Last update: 2017-12-12 18:51    [W:0.359 / U:0.252 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site