lkml.org 
[lkml]   [2017]   [Nov]   [29]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
    Patch in this message
    /
    From
    Subject[PATCH v2 6/8] ARM: dts: imx6: RDU2: Fix the audio CODEC's reset pin
    Date
    The correct DT property for specifying a GPIO used for reset
    is "reset-gpios", fix this here.

    Fixes: d763762e3b58 ("ARM: dts: imx6: add ZII RDU2 boards")

    Signed-off-by: Andrew F. Davis <afd@ti.com>
    ---
    arch/arm/boot/dts/imx6qdl-zii-rdu2.dtsi | 4 ++--
    1 file changed, 2 insertions(+), 2 deletions(-)

    diff --git a/arch/arm/boot/dts/imx6qdl-zii-rdu2.dtsi b/arch/arm/boot/dts/imx6qdl-zii-rdu2.dtsi
    index 7812fbac963c..1b465e5a06cf 100644
    --- a/arch/arm/boot/dts/imx6qdl-zii-rdu2.dtsi
    +++ b/arch/arm/boot/dts/imx6qdl-zii-rdu2.dtsi
    @@ -337,7 +337,7 @@
    AVDD-supply = <&reg_3p3v>;
    IOVDD-supply = <&reg_3p3v>;
    DVDD-supply = <&vgen4_reg>;
    - gpio-reset = <&gpio1 2 GPIO_ACTIVE_HIGH>;
    + reset-gpios = <&gpio1 2 GPIO_ACTIVE_LOW>;
    };

    accel@1c {
    @@ -525,7 +525,7 @@
    AVDD-supply = <&reg_3p3v>;
    IOVDD-supply = <&reg_3p3v>;
    DVDD-supply = <&vgen4_reg>;
    - gpio-reset = <&gpio1 0 GPIO_ACTIVE_HIGH>;
    + reset-gpios = <&gpio1 0 GPIO_ACTIVE_LOW>;
    };

    touchscreen@20 {
    --
    2.15.0
    \
     
     \ /
      Last update: 2017-11-29 18:16    [W:2.094 / U:0.464 seconds]
    ©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site