lkml.org 
[lkml]   [2017]   [Nov]   [16]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
Patch in this message
/
From
Date
Subject[PATCH v2] typec: tcpm: fusb302: Resolve out of order messaging events
The expectation in the FUSB302 driver is that a TX_SUCCESS event
should occur after a message has been sent, but before a GCRCSENT
event is raised to indicate successful receipt of a message from
the partner. However in some circumstances it is possible to see
the hardware raise a GCRCSENT event before a TX_SUCCESS event
is raised. The upshot of this is that the GCRCSENT handling portion
of code ends up reporting the GoodCRC message to TCPM because the
TX_SUCCESS event hasn't yet arrived to trigger a consumption of it.
When TX_SUCCESS is then raised by the chip it ends up consuming the
actual message that was meant for TCPM, and this incorrect sequence
results in a hard reset from TCPM.

To avoid this problem, this commit moves all FIFO reading to be
done based on a GCRCSENT event, and when reading from the FIFO
any GoodCRC messages read in are discarded so only valid messages
are reported to TCPM.

Changes in v2:
- Remove erroneous extended header check

Patch is based on Linux next-20171114 to include move out of staging.

Signed-off-by: Adam Thomson <Adam.Thomson.Opensource@diasemi.com>
---
drivers/usb/typec/fusb302/fusb302.c | 16 ++++++++++------
1 file changed, 10 insertions(+), 6 deletions(-)

diff --git a/drivers/usb/typec/fusb302/fusb302.c b/drivers/usb/typec/fusb302/fusb302.c
index 72cb060..ddf88f0 100644
--- a/drivers/usb/typec/fusb302/fusb302.c
+++ b/drivers/usb/typec/fusb302/fusb302.c
@@ -1650,12 +1650,6 @@ static irqreturn_t fusb302_irq_intn(int irq, void *dev_id)

if (interrupta & FUSB_REG_INTERRUPTA_TX_SUCCESS) {
fusb302_log(chip, "IRQ: PD tx success");
- /* read out the received good CRC */
- ret = fusb302_pd_read_message(chip, &pd_msg);
- if (ret < 0) {
- fusb302_log(chip, "cannot read in GCRC, ret=%d", ret);
- goto done;
- }
tcpm_pd_transmit_complete(chip->tcpm_port, TCPC_TX_SUCCESS);
}

@@ -1671,12 +1665,22 @@ static irqreturn_t fusb302_irq_intn(int irq, void *dev_id)

if (interruptb & FUSB_REG_INTERRUPTB_GCRCSENT) {
fusb302_log(chip, "IRQ: PD sent good CRC");
+retry:
ret = fusb302_pd_read_message(chip, &pd_msg);
if (ret < 0) {
fusb302_log(chip,
"cannot read in PD message, ret=%d", ret);
goto done;
}
+
+ /*
+ * Check to make sure we've not read off a GoodCRC message.
+ * If so then read again to retrieve expected message
+ */
+ if ((!pd_header_cnt_le(pd_msg.header)) &&
+ (pd_header_type_le(pd_msg.header) == PD_CTRL_GOOD_CRC))
+ goto retry;
+
tcpm_pd_receive(chip->tcpm_port, &pd_msg);
}
done:
--
1.9.1
\
 
 \ /
  Last update: 2017-11-17 17:17    [W:0.055 / U:1.660 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site