Messages in this thread | | | Date | Sat, 21 Oct 2017 08:19:02 -0700 | From | Tejun Heo <> | Subject | Re: [PATCH v2 2/9] ata: ceva: Move sata port phy oob settings to device-tree |
| |
On Mon, Aug 21, 2017 at 01:17:17PM +0200, Michal Simek wrote: > From: Anurag Kumar Vulisha <anurag.kumar.vulisha@xilinx.com> > > In SATA Speed negotiation happens with OOB(Out of Band) signals. These OOB > signal timing values are configured through vendor specific registers in the > SATA controller. These OOB timings depends on the generator and detector clock > frequency, which varies from board to board (ex: ep108 and zc1751 has different > clock frequencies). > To avoid maintaing these OOB settings in the driver, it is better to move these > settings to the device-tree node and read from the device-tree. > > This patch does the same. > > Signed-off-by: Anurag Kumar Vulisha <anuragku@xilinx.com> > Signed-off-by: Michal Simek <michal.simek@xilinx.com>
Applied to libata/for-4.15.
Thanks.
-- tejun
| |