lkml.org 
[lkml]   [2017]   [Oct]   [13]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
Patch in this message
/
From
Subject[PATCH 2/7] ARM: dts: imx6ul-txul: specify ethernet phy reset post-delay
Date
Under certain circumstances the ethernet PHY cannot be detected on
Ka-Ro electronics TXUL modules. Using a phy-reset-post-delay of > 5ms
alleviates this problem. Specify a value of 10ms to be on the safe side.

Signed-off-by: Lothar Waßmann <LW@KARO-electronics.de>
---
arch/arm/boot/dts/imx6ul-tx6ul.dtsi | 1 +
1 file changed, 1 insertion(+)

diff --git a/arch/arm/boot/dts/imx6ul-tx6ul.dtsi b/arch/arm/boot/dts/imx6ul-tx6ul.dtsi
index d30c4e05..9e2a966 100644
--- a/arch/arm/boot/dts/imx6ul-tx6ul.dtsi
+++ b/arch/arm/boot/dts/imx6ul-tx6ul.dtsi
@@ -308,6 +308,7 @@
pinctrl-0 = <&pinctrl_enet1 &pinctrl_enet1_mdio &pinctrl_etnphy0_rst>;
phy-mode = "rmii";
phy-reset-gpios = <&gpio5 6 GPIO_ACTIVE_LOW>;
+ phy-reset-post-delay = <10>;
phy-supply = <&reg_3v3_etn>;
phy-handle = <&etnphy0>;
status = "okay";
--
2.1.4
\
 
 \ /
  Last update: 2017-10-13 12:44    [W:0.068 / U:7.212 seconds]
©2003-2017 Jasper Spaans. hosted at Digital OceanAdvertise on this site