lkml.org 
[lkml]   [2017]   [Oct]   [10]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
From
SubjectRe: [PATCH v3 1/1] mtd: nand: pxa3xx: Set FORCE_CSX bit to ARMADA370 variants.
Date
Hello Miquel,
On 09/10/17 19:18, Miquel RAYNAL wrote:
> Hello Kalyan,
>
> On Mon, 9 Oct 2017 02:31:30 +0000
> Kalyan Kinthada <Kalyan.Kinthada@alliedtelesis.co.nz> wrote:
>
>> On 05/10/17 20:41, Miquel RAYNAL wrote:
>>> Hello Kalyan,
>>>
>>> On Thu, 28 Sep 2017 13:57:56 +1300
>>> Kalyan Kinthada <kalyan.kinthada@alliedtelesis.co.nz> wrote:
>>>
>>>> When the arbitration between NOR and NAND flash is enabled
>>>> the <FORCE_CSX> field bit[21] in the Data Flash Control Register
>>>> needs to be set to 1 according to guidleine GL-5830741 mentioned
>>> Typo: guideline ^
>> I will correct this typo in the next patch version.
>>>> in Marvell Errata document MV-S501377-00, Rev. D.
>>> Thanks for that, I checked it.
>>>
>>>> This commit sets the FORCE_CSX bit to 1 for all
>>>> ARMADA370 variants as the arbitration is always enabled by default.
>>>> This change does not apply for pxa3xx variants because the
>>>> FORCE_CSX bit does not exist/reserved on the NFCv1.
>>> Sorry to bother you again but I am reworking the pxa3xx_nand driver
>>> and so I would like to deeply understand why this is needed because
>>> I will have to integrate it in my work too.
>>>
>>> So please tell me what is your setup, do you really use NAND/NOR
>>> arbitration? Do you have not-Don't Care CS NAND chips? I have some
>>> doubts because even if the spec precises in the NAND controller
>>> chapter that arbitration is always enabled by default, the bit 27
>>> (NfArbiterEn) in the SoC Device Multiplex Register at offset
>>> 0x00018208 is actually at 0 by default (disabled). Did you enable
>>> this bit manually ? I checked with devmem on my setup and this bit
>>> was unset.
>> Yes, my setup use NAND/NOR arbitration and use a Don't
>> care CS Nand Chip. The bit 27 at offset 0x00018208 is set to 1
>> by default in my case. I did not manually set the bit 27 to 1.
> Actually if you use Don't Care CS NAND chips you should not need the
> force CS bit, as it is mentioned in the guidelines you pointed, this
> bit is only useful for *not* don't care CS NAND chips (and the name
> "force CS" is pretty straight forward too!).
Ok. I understand now. Thank you.
>
> Otherwise what bootloader and kernel do you use to have this
> bit set by default? You may also want to check if this bit is set by
> your bootloader by stopping it before it loads Linux and check manually
> the value of this bit with 'md' (on U-Boot).
The bit27 at offset 0x00018208 is set in bootloader.
Uboot version 2016.11
Linux Kernel 4.4.6

Thanks,
Kalyan
>
> Thank you,
> Miquèl
>
>> Please let me now if you have any other question or do you want me
>> to send the updated patch version with the typo fixed.
>>
>> Thank You,
>> Kalyan
>>
>>> Thank you for your time,
>>> Miquèl
>>>
>>>> The NDCR_ND_MODE conflicts with the new NDCR_FORCE_CSX but is
>>>> unused so remove it along with NDCR_NAND_MODE.
>>>>
>>>> Signed-off-by: Kalyan Kinthada
>>>> <kalyan.kinthada@alliedtelesis.co.nz> ---
>>>
>>>> drivers/mtd/nand/pxa3xx_nand.c | 9 +++++++--
>>>> 1 file changed, 7 insertions(+), 2 deletions(-)
>>>>
>>>> diff --git a/drivers/mtd/nand/pxa3xx_nand.c
>>>> b/drivers/mtd/nand/pxa3xx_nand.c index 85cff68643e0..a6a7a5af7bed
>>>> 100644 --- a/drivers/mtd/nand/pxa3xx_nand.c
>>>> +++ b/drivers/mtd/nand/pxa3xx_nand.c
>>>> @@ -67,8 +67,7 @@
>>>> #define NDCR_DWIDTH_M (0x1 << 26)
>>>> #define NDCR_PAGE_SZ (0x1 << 24)
>>>> #define NDCR_NCSX (0x1 << 23)
>>>> -#define NDCR_ND_MODE (0x3 << 21)
>>>> -#define NDCR_NAND_MODE (0x0)
>>>> +#define NDCR_FORCE_CSX (0x1 << 21)
>>>> #define NDCR_CLR_PG_CNT (0x1 << 20)
>>>> #define NFCV1_NDCR_ARB_CNTL (0x1 << 19)
>>>> #define NFCV2_NDCR_STOP_ON_UNCOR (0x1 << 19)
>>>> @@ -1464,6 +1463,9 @@ static int pxa3xx_nand_config_ident(struct
>>>> pxa3xx_nand_info *info) info->chunk_size = PAGE_CHUNK_SIZE;
>>>> info->reg_ndcr = 0x0; /* enable all interrupts */
>>>> info->reg_ndcr |= (pdata->enable_arbiter) ?
>>>> NDCR_ND_ARB_EN : 0;
>>>> + /* Set FORCE_CSX bit for all ARMADA370 Variants. Ref#:
>>>> GL-5830741 */
>>>> + if (info->variant == PXA3XX_NAND_VARIANT_ARMADA370)
>>>> + info->reg_ndcr |= NDCR_FORCE_CSX;
>>>> info->reg_ndcr |= NDCR_RD_ID_CNT(READ_ID_BYTES);
>>>> info->reg_ndcr |= NDCR_SPARE_EN;
>>>>
>>>> @@ -1498,6 +1500,9 @@ static void pxa3xx_nand_detect_config(struct
>>>> pxa3xx_nand_info *info) info->reg_ndcr = ndcr &
>>>> ~(NDCR_INT_MASK | NDCR_ND_ARB_EN |
>>>> NFCV1_NDCR_ARB_CNTL); info->reg_ndcr |= (pdata->enable_arbiter) ?
>>>> NDCR_ND_ARB_EN : 0;
>>>> + /* Set FORCE_CSX bit for all ARMADA370 Variants. Ref#:
>>>> GL-5830741 */
>>>> + if (info->variant == PXA3XX_NAND_VARIANT_ARMADA370)
>>>> + info->reg_ndcr |= NDCR_FORCE_CSX;
>>>> info->ndtr0cs0 = nand_readl(info, NDTR0CS0);
>>>> info->ndtr1cs0 = nand_readl(info, NDTR1CS0);
>>>> }
>>>
>
>
\
 
 \ /
  Last update: 2017-10-10 22:29    [W:0.094 / U:0.216 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site