lkml.org 
[lkml]   [2017]   [Jan]   [8]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
SubjectRe: [PATCH 2/2] media: rc: add driver for IR remote receiver on MT7623 SoC
From
Date
On Sun, 2017-01-08 at 21:16 +0000, Sean Young wrote:
> Hi Sean,
>
> On Fri, Jan 06, 2017 at 03:31:25PM +0800, Sean Wang wrote:
> > On Thu, 2017-01-05 at 17:12 +0000, Sean Young wrote:
> > > On Fri, Jan 06, 2017 at 12:06:24AM +0800, sean.wang@mediatek.com wrote:
> > > > + /* Handle pulse and space until end of message */
> > > > + for (i = 0 ; i < MTK_CHKDATA_SZ ; i++) {
> > > > + val = mtk_r32(ir, MTK_CHKDATA_REG(i));
> > > > + dev_dbg(ir->dev, "@reg%d=0x%08x\n", i, val);
> > > > +
> > > > + for (j = 0 ; j < 4 ; j++) {
> > > > + wid = (val & (0xff << j * 8)) >> j * 8;
> > > > + rawir.pulse = !rawir.pulse;
> > > > + rawir.duration = wid * (MTK_IR_SAMPLE + 1);
> > > > + ir_raw_event_store_with_filter(ir->rc, &rawir);
> > > > +
> > > > + if (MTK_IR_END(wid))
> > > > + goto end_msg;
> > > > + }
> > > > + }
> > >
> > > If I read this correctly, there is a maximum of 17 * 4 = 68 edges per
> > > IR message. The rc6 mce key 0 (scancode 0x800f0400) is 69 edges, so that
> > > won't work.
> > >
> > Uh, this is related to hardware limitation. Maximum number hardware
> > holds indeed is only 68 edges as you said :(
> >
> > For the case, I will try change the logic into that the whole message
> > is dropped if no end of message is seen within 68 counts to avoid
> > wasting CPU for decoding.
>
> I'm not sure it is worthwhile dropping the IR in that case. The processing
> is minimal and it might be possible that we have just enough IR to decode
> a scancode even if the trailing end of message is missing. Note that
> the call to ir_raw_event_set_idle() will generate an timeout IR event, so
> there will always be an end of message marker.


1)
I agree with you :) The original logic I made already as you pointed out
is sent incomplete IR message to let ir-raw try to decode as possible.

2)
I had another question. I found multiple and same IR messages being
received when using SONY remote controller. Should driver needs to
report each message or only one of these to the upper layer ?


> All I wanted to do was point out a limitation in case there is a
> workaround; if there is not then we might as well make do with the IR
> we do have.

I also will leave some words about limitation we had in the comments.

> Thanks
> Sean


\
 
 \ /
  Last update: 2017-01-09 04:14    [W:0.069 / U:0.544 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site