lkml.org 
[lkml]   [2017]   [Jan]   [22]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
Date
From
SubjectRe: [PATCH] clk: qcom: gdsc: Fix handling of hw control enable/disable

[]..

>> ---
>>
>> Stan,
>> If there was a specific issue you saw with venus because of the missing
>> delay and poll, can you check if this fixes any of that.
>>
>> drivers/clk/qcom/gdsc.c | 58 ++++++++++++++++++++++++++++++++++++++-----------
>> 1 file changed, 45 insertions(+), 13 deletions(-)
>>
>> diff --git a/drivers/clk/qcom/gdsc.c b/drivers/clk/qcom/gdsc.c
>> index 288186c..6fbd6df 100644
>> --- a/drivers/clk/qcom/gdsc.c
>> +++ b/drivers/clk/qcom/gdsc.c
>> @@ -63,11 +63,26 @@ static int gdsc_hwctrl(struct gdsc *sc, bool en)
>> return regmap_update_bits(sc->regmap, sc->gdscr, HW_CONTROL_MASK, val);
>> }
>>
>> +static int gdsc_poll_status(struct gdsc *sc, unsigned int reg, bool val)
>
> Could you rename 'val' to 'en'.

yes, I seem to have messed up with the value to write into the register and
the one to poll. I will fix this up and post a v2.

>
>> +{
>> + ktime_t start;
>> +
>> + start = ktime_get();
>> + do {
>> + if (gdsc_is_enabled(sc, reg) == val)
>> + return 0;
>> + } while (ktime_us_delta(ktime_get(), start) < TIMEOUT_US);
>> +
>> + if (gdsc_is_enabled(sc, reg) == val)
>> + return 0;
>> +
>> + return -ETIMEDOUT;
>> +}
>> +
>> static int gdsc_toggle_logic(struct gdsc *sc, bool en)
>> {
>> int ret;
>> u32 val = en ? 0 : SW_COLLAPSE_MASK;
>> - ktime_t start;
>> unsigned int status_reg = sc->gdscr;
>>
>> ret = regmap_update_bits(sc->regmap, sc->gdscr, SW_COLLAPSE_MASK, val);
>> @@ -100,16 +115,7 @@ static int gdsc_toggle_logic(struct gdsc *sc, bool en)
>> udelay(1);
>> }
>>
>> - start = ktime_get();
>> - do {
>> - if (gdsc_is_enabled(sc, status_reg) == en)
>> - return 0;
>> - } while (ktime_us_delta(ktime_get(), start) < TIMEOUT_US);
>> -
>> - if (gdsc_is_enabled(sc, status_reg) == en)
>> - return 0;
>> -
>> - return -ETIMEDOUT;
>> + return gdsc_poll_status(sc, status_reg, en);
>> }
>>
>> static inline int gdsc_deassert_reset(struct gdsc *sc)
>> @@ -188,8 +194,19 @@ static int gdsc_enable(struct generic_pm_domain *domain)
>> udelay(1);
>>
>> /* Turn on HW trigger mode if supported */
>> - if (sc->flags & HW_CTRL)
>> - return gdsc_hwctrl(sc, true);
>> + if (sc->flags & HW_CTRL) {
>> + ret = gdsc_hwctrl(sc, true);
>> + /*
>> + * Wait for the GDSC to go through a power down and
>> + * up cycle. In case a firmware ends up polling status
>> + * bits for the gdsc, it might read an 'on' status before
>> + * the GDSC can finish the power cycle.
>> + * We wait 1us before returning to ensure the firmware
>> + * can't immediately poll the status bits.
>> + */
>> + mb();
>
> Missing comment for this memory barrier, although I think it is
> pointless because regmap-mmio using readl and writel.

will get rid of the barrier here and below

>
>
>> + udelay(1);
>> + }
>>
>> return 0;
>> }
>> @@ -204,9 +221,24 @@ static int gdsc_disable(struct generic_pm_domain *domain)
>>
>> /* Turn off HW trigger mode if supported */
>> if (sc->flags & HW_CTRL) {
>> + unsigned int reg;
>> +
[]..

>
>> + udelay(1);
>> +
>> + reg = sc->gds_hw_ctrl ? sc->gds_hw_ctrl : sc->gdscr;
>> + ret = gdsc_poll_status(sc, reg, 0);
>
> This should be gdsc_poll_status(sc, reg, true) because after disabling
> hw_control we expect that the GDSC is in power_on state.

correct, will fix. thanks for the review.


--
Qualcomm Innovation Center, Inc. is a member of Code Aurora Forum,
hosted by The Linux Foundation

\
 
 \ /
  Last update: 2017-01-23 05:07    [W:0.094 / U:0.252 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site