lkml.org 
[lkml]   [2017]   [Jan]   [20]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
SubjectRe: [PATCH v3 00/24] i.MX Media Driver
From
Date
Hi Steve, Philipp,

On 01/07/2017 03:11 AM, Steve Longerbeam wrote:
> In version 3:
>
> Changes suggested by Rob Herring <robh@kernel.org>:
>
> - prepended FIM node properties with vendor prefix "fsl,".
>
> - make mipi csi-2 receiver compatible string SoC specific:
> "fsl,imx6-mipi-csi2" instead of "fsl,imx-mipi-csi2".
>
> - redundant "_clk" removed from mipi csi-2 receiver clock-names property.
>
> - removed board-specific info from the media driver binding doc. These
> were all related to sensor bindings, which already are (adv7180)
> or will be (ov564x) covered in separate binding docs. All reference
> board info not related to DT bindings has been moved to
> Documentation/media/v4l-drivers/imx.rst.
>
> - removed "_mipi" from the OV5640 compatible string.
>
> Changes suggested by Vladimir Zapolskiy <vladimir_zapolskiy@mentor.com>:
>
> Mostly cosmetic/non-functional changes which I won't list here, except
> for the following:
>
> - spin_lock_irqsave() changed to spin_lock() in a couple interrupt handlers.
>
> - fixed some unnecessary of_node_put()'s in for_each_child_of_node() loops.
>
> - check/handle return code from required reg property of CSI port nodes.
>
> - check/handle return code from clk_prepare_enable().
>
> Changes suggested by Fabio Estevam <festevam@gmail.com>:
>
> - switch to VGEN3 Analog Vdd supply assuming rev. C SabreSD boards.
>
> - finally got around to passing valid IOMUX pin config values to the
> pin groups.
>
> Other changes:
>
> - removed the FIM properties that overrided the v4l2 FIM control defaults
> values. This was left-over from a requirement of a customer and is not
> necessary here.
>
> - The FIM must be explicitly enabled in the fim child node under the CSI
> port nodes, using the status property. If not enabled, FIM v4l2 controls
> will not appear in the video capture driver.
>
> - brought in additional media types patch from Philipp Zabel. Use new
> MEDIA_ENT_F_VID_IF_BRIDGE in mipi csi-2 receiver subdev.
>
> - brought in latest platform generic video multiplexer subdevice driver
> from Philipp Zabel (squashed with patch that uses new MEDIA_ENT_F_MUX).
>
> - removed imx-media-of.h, moved those prototypes into imx-media.h.

Based on the discussion on the mailinglist it seems everyone agrees that this
is the preferred driver, correct?

There are a bunch of review comments, so I will wait for a v4. I plan to merge
that staging driver unless there are major issues with it.

I am not sure if I would merge those sensor drivers in staging, I'll have to
take a closer look at those once v4 is posted.

Regards,

Hans

\
 
 \ /
  Last update: 2017-01-20 14:55    [W:0.966 / U:0.444 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site