lkml.org 
[lkml]   [2017]   [Jan]   [15]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
SubjectRe: [PATCH 02/19] staging: iio: isl29028: remove enable flag from isl29028_enable_proximity()
From
Date
On 14/01/17 20:00, Brian Masney wrote:
> On Sun, Dec 04, 2016 at 11:16:04AM +0000, Jonathan Cameron wrote:
>> On 04/12/16 02:19, Brian Masney wrote:
>>> isl29028_enable_proximity() has a boolean argument named enable. This
>>> function is only called once and the enable flag is set to true in that
>>> call. This patch removes the enable parameter from that function.
>>>
>>> Signed-off-by: Brian Masney <masneyb@onstation.org>
>>
>> The first thing that strikes me about this, is why do we have an enable
>> only function?
>>
>> I think the intention was probably that we also disable the proximity
>> sensing after the
>> reading was done... Ideally we'd do this a little more cleverly,
>> perhaps using runtime
>> pm so that if someone is requesting a stream of proximity measurements,
>> we won't end up
>> powering up and down each time.
>>
>> It's a little 'interesting' as we would want to power this element down
>> even if we do
>> have a continuous stream of reads on the ALS. As such we may need to
>> roll our own
>> equivalent of runtime pm.
>>
>> In the first instance, I'd just put a disable after the reading is
>> taken. This will
>> make a bit of a mockery of the faster sampling frequencies but there we
>> are!
>>
>> ---------------------
>>
>> On second thoughts (stupid email is hiding somewhere to be sent when I
>> have wifi so can't reply to it) perhaps this is a coarse way of only
>> turning proximity on if the LED is present? Not sure...
>
> Hi Jonathan,
>
> I chained your two replies together above. I am probably stating the
> obvious here, but I've verified with an oscilloscope that the IRDR pin
> that drives the external LED is off when the chip is first initialized
> and ALS readings are taken. The IRDR pin fluctuates between high and low
> every 100us (if memory serves me right) once the first proximity reading
> is taken until the chip is suspended.
>
> What do you think about enabling runtime auto suspend after say 2
> seconds for the whole device? There is the situation that you describe
> where if someone is continuously polling the ALS but asks for a single
> proximity reading. The external LED will stay on in that case. Once the
> chip is suspended, and later resumes, the IRDR pin that drives the
> external LED will be off until the user asks for another proximity
> reading. That would allow for the faster sampling frequency.
>
> If you still prefer, I'll go the route of shutting down the IRDR pin
> after a proximity reading is taken.
Perhaps runtime auto suspend for the whole thing is the simplest option.
I don't mind that much either way.

Jonathan
>
> Brian
>

\
 
 \ /
  Last update: 2017-01-15 15:34    [W:1.102 / U:1.008 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site