lkml.org 
[lkml]   [2017]   [Jan]   [10]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
Date
From
SubjectRe: [PATCH v2 6/6] arm64: allwinner: a64: Increase the MMC max frequency
Hi,

On Tue, Jan 10, 2017 at 01:01:20AM +0800, Chen-Yu Tsai wrote:
> On Tue, Jan 10, 2017 at 12:46 AM, Maxime Ripard
> <maxime.ripard@free-electrons.com> wrote:
> > All the controllers can have a maximum frequency of 200MHz.
> >
> > Since older SoCs cannot go that high, we cannot change the default maximum
> > frequency, but fortunately for us we have a property for that in the DT.
> >
> > This also has the side effect of allowing to use the MMC HS200 mode for the
> > boards that support it (with either 1.2v or 1.8v IOs).
> >
> > Signed-off-by: Maxime Ripard <maxime.ripard@free-electrons.com>
> > ---
> > arch/arm64/boot/dts/allwinner/sun50i-a64.dtsi | 3 +++
> > 1 file changed, 3 insertions(+), 0 deletions(-)
> >
> > diff --git a/arch/arm64/boot/dts/allwinner/sun50i-a64.dtsi b/arch/arm64/boot/dts/allwinner/sun50i-a64.dtsi
> > index 8e149498e096..f46ae965cf5b 100644
> > --- a/arch/arm64/boot/dts/allwinner/sun50i-a64.dtsi
> > +++ b/arch/arm64/boot/dts/allwinner/sun50i-a64.dtsi
> > @@ -332,6 +332,7 @@
> > resets = <&ccu RST_BUS_MMC0>;
> > reset-names = "ahb";
> > interrupts = <GIC_SPI 60 IRQ_TYPE_LEVEL_HIGH>;
> > + max-frequency = <200000000>;
>
> You also have to set one of MMC_CAP2_HS200* in the driver,
> or mmc-hs200-1_8v or mmc-hs200-1_2v in the device tree to
> actually use HS200, right?

Yes, but that requires a board with 1.8V IOs to work properly, which
not all board use, so it's probably best to enable it in the board
DTS.

Thanks!
Maxime

--
Maxime Ripard, Free Electrons
Embedded Linux and Kernel engineering
http://free-electrons.com
[unhandled content-type:application/pgp-signature]
\
 
 \ /
  Last update: 2017-01-10 20:17    [W:0.254 / U:2.152 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site